Table of Contents
Advertisement
Emission Control (Exhaust & Evaporative)
EPA 2010 and Later and/or C.A.R.B. TIER III
The emission control system for the engine is EM/TWC (Engine Modification and 3-way Catalyst) and for the fuel tank
the Control System is EVAP (Evaporative Emissions) or N (for nylon tank). Evaporative emission may be applicable to
California models only.
An Emission Control Label is located on the unit. (This is an EXAMPLE ONLY; information on label varies by en-
gine FAMILY).
PRODUCT EMISSION DURABILITY (EMISSION COMPLIANCE PERIOD)
The 300 hour emission compliance period is the time span selected by the manufacturer certifying the engine
emissions output meets applicable emissions regulations, provided that approved maintenance procedures are
followed as listed in the Maintenance Section of this manual.
Assembly
This unit comes fully assembled with
the exception of the handlebar, cut-
ting attachment shield and cutting
attachment.
IMPORTANT!
The terms "left", "left-hand", and
"LH"; "right", "right-hand", and "RH";
"front" and "rear" refer to directions as
viewed by the operator during normal
operation.
Handlebar Assembly
Install the handlebar:
1.
Remove four (4) upper cap retaining
screws, and remove upper cap from
handlebar mounting bracket.
2.
Place handlebar on mounting
bracket, and secure with upper cap
and four (4) screws.
3.
Adjust handlebar position for best
operator comfort and control, then
tighten upper and lower cap retain-
ing screws securely.
4.
Secure cable to outer tube with two
(2) bands provided.
6
Prior to Assembly
Before assembling, make sure you have
all the components required for a com-
plete unit and inspect unit and compo-
nents for any damage.
■
Engine/Outer tube assembly
■
Handlebar and Throttle assembly
■
Cutting attachment shield
Handlebar
Outer Tube
Lower Cap
Retaining Screws
Mounting the brushcutter handlebar
■
Cutting attachment
■
Kit containing cutting attachment
shield mounting bracket and hard-
ware, this owner's/operator's manual
and tool kit for routine maintenance.
Tool kits vary by model.
Strap
Hanger
Handle Positioning Label
Lower cap
Advertisement
Table of Contents
