Sherwood Newcastle R-872 Operating Instructions Manual page 65

When selecting the SPEAKER CROSSOVER
• Set the crossover frequency according to the frequency characteristics of the speakers connected.
(For details on the frequency characteristics, refer to the operating instructions of the speakers.)
• If the frequency range of your speaker is 100 Hz ~ 20 kHz, the crossover frequency should be set to 100 Hz
(or slightly higher).
• The low frequencies below the crossover frequency are to output from subwoofer or the speakers which are
set to "FULL RANGE" (when not using a subwoofer).
1.
Press the CURSOR UP(▲)/DOWN(▼) buttons to select the SPEAKER CROSSOVER, then press the
ENTER button.
2.
Press the CURSOR UP(▲)/DOWN(▼) buttons to select the desired speaker.
3.
Press the CURSOR LEFT(◀)/RIGHT(▶) buttons to set the crossover frequency as desired.
4.
Repeat the above steps 2 and 3 until the crossover frequencies are all set as desired.
Note :
• You cannot select the subwoofer and the speakers
set to "NO".
• You can adjust the crossover frequency within the
range of 40 ~ 250 Hz.
• Select "FULL RANGE" when the selected speaker
can fully reproduce the low frequencies below 40 Hz.
65