Table of Contents
Advertisement
example the project folder location will be C:\FIT.
11. Select the Tool drop-down menu and change the tool type to USB Direct.
12. Connect the USB 2.0 A Male to Micro USB 5 pin Male Cable to the FIT. See Figure 32.
13. Remove the programming jumper W6 located on the FIT to the left of the power switch and
turn the FIT power switch to the On position.
46
Figure 31: Create New Project Window—Settings
MS-FIT100-0 Field Inspection Tool User Guide
Advertisement
Table of Contents
Need help?
Do you have a question about the MS-FIT100-0 and is the answer not in the manual?