Installing Speakers - Sharp SD-EX220 Operation Manual

Installing speakers

1
Fix the pattern paper and drive two screws into the wall with a dis-
tance of 6-5/16" (160 mm) in between. When mounting vertically,
set the distance to 4-5/16" (110 mm).
(Horizontal position)
)
0 m m
6 " ( 1 6
6 - 5 / 1
Pattern paper
for speaker
2
Tighten the screws and remove the paper. Hook the speaker on the
screw heads and make sure it is secure.
(Horizontal position)
Speaker
wire
Wall surface
Put the speaker wire in the groove on the back of the speaker.
(Vertical position)
)
0 m m
6 " ( 1 1
4 - 5 / 1
Pattern paper
for speaker
(Vertical position)
Speaker
wire
Wall surface
Notes:
Place speakers with the tweeter on the outside. Left and right speakers should
always be positioned symmetrically.
(Horizontal position)
Tweeter Tweeter
There are four VESA (*) screw holes on the back of the main unit and speakers.
You can also use commercially available fittings for mounting.
Be sure to install the product according to the method recommended by the
bracket manufacturer.
(Main unit)
(*) VESA (Video Electronics Standards Association) is an organization to promote
the standardization of digital imaging device for PCs.
(Vertical position)
Tweeter Tweeter
(Speaker)
SD-EX220
15