Adjusting The Computer Image - Sharp XV-Z7000E Operation Manual

Computer Image Adjustments (INPUT 2 (RGB) mode only)
Projector
ON/OFF
LAMP
POWER
TEMP.
KEYSTONE
INPUT PICT MODE
BACK ENTER MENU
(GUI) On-screen Display
27
Remote control
VOL
POWER
2, 3, 4
MUTE
2, 3
BACK
MENU
1, 5
ENTER

Adjusting the Computer Image

When displaying computer patterns which are very
detailed (tiling, vertical stripes, etc.), interference may
occur between the LCD pixels, causing flickering,
vertical stripes, or contrast irregularities in portions of
the screen. Should this occur, adjust "Clock", "Phase",
"H-Pos" and "V-Pos" for the optimum computer image.
Description of Adjustment Items
Selected item Description
Clock Adjusts vertical noise.
Phase Adjusts horizontal noise (similar to tracking on your VCR).
H-Pos Centres the on-screen image by moving it to the left or right.
V-Pos Centres the on-screen image by moving it up or down.
• Computer image adjustments can be made easily by
pressing AUTO SYNC ( ). See page 26 for details.
Select the desired computer input mode with INPUT
(
on the projector or INPUT 2 on the remote control.)
1 Press MENU.
2 Press ∂/ƒ to select "Fine Sync", and then press
ENTER.
3 Press ∂/ƒ to select a specific adjustment item,
and then press ENTER.
4 Press ∂/ƒ to move the
adjustment item to the desired setting.
5 To exit from the GUI, press MENU.
• The value range of "Clock" setting is limited by the type of
signal received.
• To reset all adjustment items, select "Reset" on the "Fine
Sync" menu screen and press ENTER.
mark of the selected