Sharp XV-Z7000E Operation Manual page 16

Basic Operations
Projector
ON/OFF
LAMP
POWER
TEMP.
KEYSTONE
INPUT PICT MODE
BACK ENTER MENU
EXAMPLE
5
INPUT 1 Mode
d
VIDEO Mode
6
7
8
Remote control
8
VOL
6
POWER
MUTE
BACK
7
MENU
5
ENTER
RGB/
INPUT 1 COMPONENT PICT MODE
INPUT 2 AUTO SYNC GAMMA
S-VIDEO CLR TEMP
VIDEO KEYSTONE FREEZE
INPUT 2 Mode
g
f
S-VIDEO Mode
s
5 Press INPUT on the projector, INPUT 1, INPUT 2,
S-VIDEO or VIDEO on the remote control to select
the desired input mode.
Press INPUT, INPUT 1, INPUT 2, S-VIDEO or
VIDEO again to change the mode.
• When the selected input signal is being received, "Adjusting
The Image" will be displayed.
• When no signal is being received, "NO SIGNAL" will be
displayed. When a signal that the projector is not preset to
receive is being received, "NOT REG." will be displayed.
6 Press VOLUME on the remote control to adjust
the volume.
7 Press MUTE on the remote control to temporarily
turn off the sound.
Press MUTE again to turn the sound back on.
8 Press ON/OFF on the projector for over one
second, or POWER on the remote control.
Press ON/OFF or POWER again while the
message is displayed.
• If you accidentally pressed ON/OFF or POWER and do not
want to turn off the power, wait until the power off screen
disappears.
• When ON/OFF or POWER is pressed twice, the POWER
indicator will light up red and the cooling fan will run for
about 90 seconds. The projector will then enter standby
mode.
• Wait until the cooling fan stops before disconnecting the
power cord.
• The power can be turned on again by pressing ON/OFF or
POWER. When the power is turned on, the POWER indicator
and the LAMP REPLACEMENT indicator light green.
• The POWER indicator flashes if the right side filter cover is
not securely installed.
WARNING:
The cooling fan in this projector continues to run for about
90 seconds after the projector is turned off. During normal
operation, when turning the power off always use the ON/
OFF button on the projector or the POWER button on the
remote control. Ensure the cooling fan has stopped before
disconnecting the power cord.
DURING NORMAL OPERATION, NEVER TURN THE
PROJECTOR OFF BY DISCONNECTING THE POWER
CORD. FAILURE TO OBSERVE THIS WILL RESULT IN
PREMATURE LAMP FAILURE.
16