pTron Force X10e User Manual

Bluetooth fitness smartwatch

Force X10e Bluetooth Fitness Smartwatch - User Manual

Important

: This Smartwatch is Not a Medical Device.

Requirements:

Android 5.0 & above | iOS 9.0 & above

Bluetooth 5.0

Caution:

1. Clean the Smartwatch regularly, especially its inner side, and keep it dry always.

2. Adjust the Smartwatch tightness to ensure air circulation.

3. Excessive skincare products should not be used on the wrist wearing the smartwatch.

4. Please cease wearing the smartwatch in case of skin allergy or any discomfort.

Power On the Watch:

Long press the crown-like button on the side of the smartwatch for 3 seconds or plug in the Magnetic

charging cable to charge the watch.

Downloading 'Da Fit' Mobile App:

1. For downloading the App go to Playstore or App Store and search 'Da Fit'. Now, download and install the

app.

Type in Your Phone Browser

http://plus.crrepa.com/app-download/dafit

Now, download and install the app.

Switch on the smartwatch, go to settings and then inside setting you will find QR code option, just click on it

you will get the QR code. Now, scan the QR code from your phone, you will get a link for downloading 'Da

Fit' app. Download and install the App in your smartphone.

1. Turn OFF the Smartwatch before Charging.

2. Simply, hold the 2-pin connector of the USB charging cable near the 2 small round magnetic charging

interfaces. The connector will get connected to the interface through the magnetic pull. It's a completely

sealed system free of exposed contacts. Plug the USB end of the cable into a DC5V/1A power source.

Table of Contents

Do you have a question about the Force X10e and is the answer not in the manual?

Page 1 Force X10e Bluetooth Fitness Smartwatch - User Manual Important : This Smartwatch is Not a Medical Device. Requirements: Android 5.0 & above | iOS 9.0 & above Bluetooth 5.0 Caution: 1. Clean the Smartwatch regularly, especially its inner side, and keep it dry always.
Page 2 Note: You can directly check the charging by pressing the crown-like button on the right side of the dial. Pressing once will show the charging status on the display. Binding Force X10e with Mobile App: 1. After mobile App installation, open the App and set up your profile.
Page 3 Sleep: Wear the smartwatch properly before sleeping, then it will provide the data of hours slept and the quality of sleep stats in the mobile App and in the smartwatch. Note: Sleep stats will get zero at 8 PM automatically. HR (Heart Rate): 1.
Page 4 9. WATCH FACES - From the app you can select the wallpaper or you can also select any of the pictures from the gallery of the connected device to set as a wallpaper in the smartwatch. Frequently Asked Question: Q1) Why does the smart watch automatically disconnect Bluetooth when the Android screen goes out? A) 1.