Table of Contents
Advertisement
CHAPTER 5 Cabling the Device
RJ-45 LAN Connector Pinouts
The RJ-45 connectors with the following pinouts are used for the LAN interfaces:
Pin
1
2
3
4
5
6
7
8
➢ To connect to the LAN:
1.
Connect one end of a straight-through RJ-45 Ethernet Cat 5, 5e, or 6 cable to the Ethernet
ports on the LAN module.
2.
Connect the other end of the cable to the LAN network.
Deployment of a Standalone Device
The Ethernet ports on the E-SBC module can operate in pairs called Ethernet Groups to provide
Ethernet port 1+1 redundancy. In each pair, one port serves as the active Ethernet port while
the other as standby. When the active port fails, the device switches to the standby Ethernet
port.
Table 5-1: RJ-45 Connector Pinouts
Name
BI_DA+
BI_DA-
BI_DB+
BI_DC+
BI_DC-
BI_DB-
BI_DD+
BI_DD-
Figure 5-2:
Connecting the LAN Interface
- 21 -
Mediant 2600 SBC | Hardware Installation Manual
Description
Bi-directional pair A+
Bi-directional pair A-
Bi-directional pair B+
Bi-directional pair C+
Bi-directional pair C-
Bi-directional pair B-
Bi-directional pair D+
Bi-directional pair D-
Advertisement
Table of Contents
