Connecting The Ethernet Ports To The Lan; Figure 5-1: Connecting The Lan Interface; Table 5-1: Rj-45 Connector Pinouts - AudioCodes Mediant 4000B SBC Hardware Installation Manual

5.1

Connecting the Ethernet Ports to the LAN

The cabling specifications and procedure for connecting the device to the LAN is as
follows:

Cable: Straight-through, Category (Cat) 5, 5e or 6 cable

Connector: Standard RJ-45

Connector Pinouts:
Pin Name
1 BI_DA+
2 BI_DA-
3 BI_DB+
4 BI_DC+
5 BI_DC-
6 BI_DB-
7 BI_DD+
8 BI_DD-

To connect to the LAN:
1. Connect the RJ-45 port at one end of the cable to an Ethernet port on the SBC
module:
2. Connect the other end of the cable to your LAN network.
Note: For initial network connectivity to the device, use ports GE 1 or GE 2 to connect to
the LAN. These ports (or this Ethernet Group) are assigned to the OAMP interface
(192.168.0.2) by default. For port names as well as Ethernet port groups (for 1+1
redundancy), see Section
Hardware Installation Manual

Table 5-1: RJ-45 Connector Pinouts

Bi-directional pair A+
Bi-directional pair A-
Bi-directional pair B+
Bi-directional pair C+
Bi-directional pair C-
Bi-directional pair B-
Bi-directional pair D+
Bi-directional pair D-

Figure 5-1: Connecting the LAN Interface

5.1.1 on page 39.
38
Mediant 4000B SBC
Description
Document #: LTRT-41749