Using Your Carpet Glider - Shark S3501WC Owner's Manual

Using Your Steam Mop - cont'd
3
3 For your comfort, you can adjust the
height of the mop. Just lift the latch
on the tube 90 degrees to the open
position. Holding the handle, extend
the tube to the height that's right for
you and then close latch to locked
position.
4 When one side of the micro-fiber
pocket gets dirty, just flip the mop
head and you can quickly start using
the other side. Dirt can't hide on
either side.
IMPORTANT: Please wait 3-5 minutes
for the Steam Mop to cool off before
switching the mop head or the
micro-fiber pockets.
6 TOLL FREE: 1-866-538-6109
S3501WC_IB_English_100119.indd 6-7
4
5 When the water tank is empty, the
steam mop will stop producing
steam. You can refill the water tank
at any time as long as the mop is
unplugged from the outlet. Follow
the instructions from page 3. This
goes for switching the mop heads or
micro-fiber pockets as well.
IMPORTANT: Never leave the steam
mop with a damp/wet micro-fiber
pocket on any floor surface for any
amount of time as this may damage
the floor.

Using Your Carpet Glider

The Steam Mop won't clean
your carpeting or area
rugs. However, it's great for
deodorizing and freshening.
THE CARPET GLIDER
1 The Carpet Glider can be used with
the rectangle mop head to lightly
steam your carpet and area rugs.
Just place the mop head on top
of the glider and move back and
forth across a section of the carpet.
The steam mop won't clean your
carpeting or areas rugs, but it's great
for deodorizing and freshening.
NOTE: Please note that the Steam
Mop rests on top of the carpet glider
and it is not a fixed attachment.
Do not leave steam mop with carpet
glider in one stationary position for
any period of time.
English
1
www.sharkclean.com 7
1/19/10 2:48 PM