Table of Contents
Advertisement
Section 4
Operation
4.1 Ignition
Refer to the section below according to which ignition system you purchased. An initial burner test
should be done prior to filling the pan with media (rocks/glass/etc.)
4.1.1 Manual Light
You will need a fireplace lighter, do not use a match or cigarette lighter as they are much shorter and will light the
fuel too close to the burner which may result in serious injury. Ignite your fireplace lighter and hold the tip close
to the burner. Insert fire table key and turn it to the ON position to start gas flow to the burner- if you are using a
propane tank unit, please note you will need to open the valve on your tank first. If your burner does not light
within 5 seconds, turn key to the OFF position and wait 10 seconds before trying again. If the burner still does not
light, call your local gas technician to determine if there is a problem. Once burner lights, immediately remove
your hand and allow burner to operate for a few minutes before turning it off. Make sure the valve is properly
closed every time you leave your fire feature unattended and remove key. For propane units, ensure that valve on
tank is completely closed when fire feature is not use.
You are now ready to place the fire media onto the burner pan. Slowly pour media onto pan and spread evenly.
Fire media should be sparsely spread out enough to cover pan. Only use the recommended amount of media in
your unit (the amount provided), overfilling may result in smaller flame and gas buildup which may cause an
explosion. Fresh air must be able to pass through the unit. Do not block or obstruct any vents on lower and upper
parts of the fire feature. These are designed to ensure proper combustion and ensure no buildup of residual gases
within the unit.
4.1.2 Electronic Ignition
Prism Hardscapes offers a separate installation guide for the Electronic PH-Ignite System. All other
electronic system guides must be requested from their corresponding manufacturers.
CAUTION: Open flames will ignite combustible materials such as clothing, fabric, hair, etc. which
may result in serious injury, property damage and/or death. Be cautious of the open flames while
burner is lit.
4.2 Adjustment
Allow the fire feature and media to cool down before moving or adjusting. This may take from 30
minutes to 1 hour depending on the size of the fire feature. Any shifting of fire media or feature should
be done after the entire unit has cooled. Also prior to movement, ensure that all gas valves are
completely closed and disconnected.
Refer to Section 1.4 for instructions on how to safely move your unit.
4.3 Caring for Unit
It is recommended to wipe the unit down before every use, and always clean any spills immediately so
as not to allow stains to set in. Cleaning can be done with mild soap, water, and a rag. We also
recommend resealing the unit after 2 years with a water-based concrete sealer
Advertisement
Table of Contents
