WARNING: THIS APPLIANCE IS FOR OUTDOOR USE ONLY! This manual should remain with the parties responsible for operation. Table of Contents Section 1: General Description 1.1 Product Dimensions 1.2 Safely Moving Fire Feature Section 2: Safety Instructions Section 3: Installation Details 3.1 Gas Requirements 3.2 Internal View of Components 3.3 Quick Connect Propane Hose...
Section 1 General Description 1.1 Product Dimensions OVALE 79 Overall Length 79" Overall Width 45" Overall Height 18" Surface 10" Burner 30”/65,000 BTUs Weight 320 lbs. Note: Enclosure should be located a minimum of 3-4ft. away from fire feature. Ensure the enclosure is not placed directly on/over the propane hose that could otherwise kink, pinch, or cut off the gas supply.
1.2 Safely Moving Fire Feature • NEVER ATTEMPT TO MOVE YOUR FIRE FEATURE BY YOURSELF • WRAP FURNITURE BLANKET AROUND THE ENTIRE BODY OF THE UNIT • PLACE A PIECE OF ¾” PLYWOOD BETWEEN DOLLY AND THE FIRE FEATURE FOR INCREASED STABILITY WHILE MOVING •...
Do not store or use gasoline or other flammable vapors and liquids within the vicinity of this or any other appliance. Prism Hardscapes strongly recommends the installation of Carbon Monoxide detectors within reach of this appliance and in any adjacent occupied spaces.
Page 7
WARNING Before installing this product, read and follow all warning notices and instructions provided. Failure to do so may result in serious injury, property damage and/or death. For additional product reference and copies of these instructions, visit our website at prismhardsacapes.com WARNING This appliance may produce carbon monoxide which has no odor.
Section 3 Installation Details 3.1 Gas Requirements The fire feature should be placed on a flat and level surface. It will arrive with the burner and burner plate set inside the unit. Burner hardware has been installed at the factory but will need to be checked for proper tightness after transportation.
Page 9
3.3 Propane Gas Quick Connection The fire feature is equipped with a quick connect brass connection. Coupled with the brass connection on the propane hose to quickly and conveniently provide proper pressure to operate the fire feature as well as a sealed connection to the tank. To Connect: 1.
4.1.2 Electronic Ignition Prism Hardscapes offers a separate installation guide for the Electronic PH-Ignite System. All other electronic system guides must be requested from their corresponding manufacturers. CAUTION: Open flames will ignite combustible materials such as clothing, fabric, hair, etc. which may result in serious injury, property damage and/or death.
Section 5 Troubleshooting Refer to the section below according to issue and gas source. BURNER WILL NOT LIGHT Possible Cause How to Fix Air in Gas Line If newly installed, it may take several attempts to purge air from line. Confirm gas line is clear and free of obstruction (insulation, dirt, excess pipe sealer, Debris in Gas Line water, etc.).
Page 12
Improper Air/Fuel Remove any foreign items or other combustible materials from unit & check for Mixture proper orifice sizing. BURNER FLAME IS TOO HIGH OR TOO LOW Possible Cause How to Fix Incorrect Gas Supply Propane Gas Units: Inspect propane tank and hose, one or both may need to be Pressure refilled or replaced.
Hardscapes will not be responsible for any defects resulting from misuse, user error, installation error, abuse, repair or alteration. The use of wood or fuels other than those specified for use with this unit by Prism Hardscapes will void warranty immediately. Under no circumstances will Prism Hardscapes be liable for incidentals or consequential damage resulting from defective products.