Download Print this page

SECOLink BS100 Installation Instruction page 2

Wireless pgm output

Advertisement

The same Operation code
5
or all BS100 from the particular module (module supports 4 x BS100):
255
Delete single
Delete all
4.3. SUPERVISORY WINDOW
The wireless device periodically sends a supervision signal to a
receiver. If the system does not receive supervision (or alarm signal)
signal from a specific device, the device is regarded as inactive. The
amount of time after which a device is considered inactive is called the
Supervisory window
.
13
Z01 BS100
7
Supervisory window
Supervisory window and periodic supervision signal sending are
directly related to selected security grade
Main menu }Service Mode }System Setup }Wireless Subsystem
Wireless Subsystem
1
Security grade
Table 1. Security grade
Periodic supervision signal
Name
Grade 1
every 1h
Custom
every 1h
Grade 2
every 20 min
5. COMMUNICATION MODE SELECTION
Wireless d
evices
, starting from version
nication mode, that can be selected in menu Mode
Service mode}System setup}Wireless Subsystem
Wireless settings
2
Mode
Table 2. Mode comparison
Mode
Distance Battery life
LR
ES
The conflict can occur when
with
the
older wireless device
new setting will not be applicable and an error will be displayed on
screen upon changing the mode, on main screen, in the corresponding
user (LT5), wireless zone or module editing menu. All errors will be
displayed until all older wireless devices will be replaced (upgraded)
OR when Mode
will be changed back to the LR .
15
6. SETTING UP ADDRESS OF THE PGM OUTPUT
Service mode }System Setup }PGM outputs
1. Press [7] or [Ų] for a next PGM output.
2. Give an appropriate name to an output
3. Enable PGM output by changing the Definition
any other depending on a specific of use.
4. Enter a wireless PGM output address in MA_P format
specifies a EXT116S or EXT116VM address in the system (where
BS100 is enrolled) and P specifies the
a
field PGM output No. in EXT
Operation code which
was used for enrolling
PGM addressing examples in Table ).
O04 BS100
1
Name
2
Address
3
Definition
5. All other PGM output settings are programmed like usual.
field is used to delete the particular BS100
254
13
1h
in the system (see Table 1).
14
Grade 1
14
Supervisory window
1h
0 - 24h (0 = disabled)
20 min
2.000
support
new commu-
:
15
15
ES (Energy Save)
Application
harsh environment for a signal to travel
(ex. concrete walls and ceilings);
long range;
less than 32 wireless devices in the system.
suitable environment for a radio signal
to travel (ex. wooden walls);
middle range;
more than 32 wl. devices in the system;
the mode
ES
is chosen in the system
15
s that supports only the
LR
.
16
from Not Used to
17
18
number
which
was entered in
OR it is the LAST digit of the
8
(see the wireless
5
3
BS100
16
06_2
18
Burglary alarm
17
Table 3. Examples of PGM address
Zone address
(BS100)
06
_
1
06
_
8
12
_
5
13 _1
Compatibility
Communication
Type
Uses
Output type
Maximum load
Tamper input
Operating frequency
Periodic supervision
signal
Supervisory window
Communication range in
building
Power supply (Vdd)
Current consumption
(without load)
Operating humidity
Operating temperature
Overall dimensions
SYSTEM COMPLIANCE & WARRANTY
Kodinis Raktas UAB, manufacturer of SECOLINK Intruder Alarm System, offers a Warranty for a term of
twenty-four months. It declares, that product complies with essential EU directives and EU standards EN
50131-1, Grade 1, Environmental Class II; EN 50131-2-2. For more information visit manufacturer's
website www.kodinis.lt or www.secolink.eu for a complete text of declaration. SECOLINK Intruder Alarm
System is designed and manufactured in Lithuania.
The warranty is given in favor of the purchaser (hereunder the "Purchaser") purchasing the products
directly from Kodinis Raktas UAB (hereunder the "Kodinis Raktas") or from its authorized distributor.
During the warranty period, manufacturer shall, at its option, repair or replace any defective product upon
return of the product to its factory, at no charge for labor and materials. Repaired products shall be
warranted for the remainder of the original warranty period. The Purchaser assumes all responsibility for
the proper selection, installation, operation and maintenance of any products purchased from Kodinis
Raktas or from its authorized distributor. To obtain service under this warranty, please return the item(s) in
question to the point of purchase. All authorized distributors and dealers have a warranty program. All
transportation costs and in-transit risk of loss or damage related, directly or indirectly, to products returned
to Kodinis Raktas for repair or replacement shall be borne solely by the Purchaser. Kodinis Raktas
warranty under this warranty does not cover products that is defective (or shall become defective) due to:
(a) alteration of the products (or any part thereof) by anyone other than Kodinis Raktas; (b) accident,
abuse, negligence, or improper maintenance; (c) failure caused by a product which Kodinis Raktas did not
provide; (d) failure caused by software or hardware which Kodinis Raktas did not provide; (e) use or
storage other than in accordance with Kodinis Raktas specified operating and storage instructions; (f) to
consumable parts, such as batteries or coatings that are designed to diminish over time. There are no
warranties, expressed or implied, of merchantability or fitness of the products for a particular purpose or
mode.
The
otherwise, which extend beyond the description on the face hereof. This limited warranty is the
Purchaser's sole and exclusive remedy against Kodinis Raktas and Kodinis Raktas sole and exclusive
liability toward the Purchaser in connection with the products, including without limitation – for defects or
malfunctions of the products. This warranty replaces all other warranties and liabilities, whether oral,
written, (non-mandatory) statutory, contractual, in tort or otherwise. In no case shall Kodinis Raktas be
liable to anyone for any consequential or incidental damages (inclusive of loss of profit, and whether
occasioned by negligence of the Kodinis Raktas or any third party on its behalf) for breach of this or any
other warranty, expressed or implied, or upon any other basis of liability whatsoever. Kodinis Raktas does
not represent that these products can not be compromised or circumvented; that these products will
prevent any person injury or property loss or damage by burglary, robbery, fire or otherwise; or that these
products will in all cases provide adequate warning or protection. Purchaser understands that a properly
installed and maintained product may in some cases reduce the risk of burglary, fire, robbery or other
events occurring without providing an alarm, but it is not insurance or a guarantee that such will not occur
or that there will be no personal injury or property loss or damage as a result. Consequently, Kodinis
Raktas shall have no liability for any personal injury; property damage or any other loss based on claim
that these products failed to give any warning. If Kodinis Raktas is held liable, whether directly or indirectly,
for any loss or damage with regards to these products, regardless of cause or origin, Kodinis Raktas
maximum liability shall not in any case exceed the purchase price of these products, which shall be the
complete and exclusive remedy against Kodinis Raktas.
, where MA
Manufacturer:
Company: UAB "Kodinis Raktas"
Address: Ateities str. 10, 08303 Vilnius, Lithuania
Tel.: +370 675 27275
E-mail: marketing@secolink.eu
Web: www.secolink.eu
Technical support:
E-mail: support@secolink.eu
Tel.: +370 659 28183
PGM output
Operation code
No. in EXT
2
1
0
2
3
1
0
3
4
1
0
4
5
1
0
5
6. SUMMARY
EXT116VM (panels P16, P32, P64),
EXT116S (system module),
EXT11 (receiver for 3rd party systems)
Dual way, encrypted
Wireless
Indoor
Open collector type (makes „minus")
50 mA / 12V DC
Yes (enabled by default)
868,30 or 915,30 MHz depending on
the country of distribution
20 min or 1h
1h (
Grade 1
),
20min (Grade 2),
0 - 24h (Custom)
up to 100 m
+12V DC ± 15%
(msg.: "low voltage" < 10V)
standby: ~13mA,
communication: ~25mA
up to 70%
from -10 up to +55 C
92 x 22 x 18 mm
CONTACT US
PGM address that
needs to be entered...
06
_
2
06
_
3
12
_
4
13
_5
o
Rev.30/09/20

Advertisement

loading
Need help?

Need help?

Do you have a question about the BS100 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel