Update - Pepperl+Fuchs VOC10M-F256-B12-V1D-CR03 Manual

Industrial Event Camera
Web Interface
5.3.4

Update

This page is used to install a software update. Select the update file and start the update using
the "Update software" button.
Note
Do not switch off the camera during the update.
Figure 5.4
First, the update file is uploaded to the camera. The upload speed depends on the network
connection between the user's computer and the camera. When the upload is complete, the
update file is checked and the update process begins. This may take a few minutes. Do not
cancel the process or interrupt the power supply to the camera while the update is taking place.
The camera restarts once the update is complete.
Note
Update fault
If something has gone wrong and the camera cannot start the new software version following a
restart, it will automatically revert to a backup copy of the old software, which is available again
after a restart.
30
Update