Maintenance Instructions; Storage Instructions; Troubleshooting - Schumacher SpeedCharge SC-1200A Owner's Manual

Schumacher battery charger user manual
Hide thumbs Also See for SpeedCharge SC-1200A:
Table of Contents

Advertisement

Available languages

Available languages

13.

MAINTENANCE INSTRUCTIONS

13.1
Before performing maintenance, unplug and disconnect battery charger
(see sections 6.7 and 7.6).
13.2
After use, unplug charger and use a dry cloth to wipe all battery corrosion
and other dirt or oil from terminals, cords, and the charger case.
13.3
Servicing does not require opening unit, as there are no user-serviceable
parts.
14.

STORAGE INSTRUCTIONS

14.1
Store charger unplugged, in an upright position. Cord will still conduct
electricity until it is unplugged from outlet.
14.2
Store inside, in a dry, cool place (unless you're using an on-board Marine
Charger ).
14.3
Do not store clips on the handle, clipped together, on or around metal, or
clipped to the cables.
15.

TROUBLESHOOTING

PROBLEM
CONNECTED (red)
light is not on.
(Models: SC-600A,
SSC-1500A, SC-
1200A)
CHECK (red)
light is not on.
(Models: SC-1000A
& SSC-1000A)
Indicator lights are lit
in an erratic manner,
not explained in the
Operating Instructions.
CONNECTED (red)
light is blinking.
(Models: SC-600A,
SSC-1500A, SC-
1200A)
POSSIBLE CAUSE
The battery is not
connected correctly.
Connection to battery is
reversed.
The battery voltage is less
than one volt.
A button may have been
pressed while the charger
was being plugged in.
Charger in abort mode.
Battery may also be
faulty. This will happen if
the battery did not reach
full charge within 48
hours. May be due
to a very large battery
or a bank of batteries
requiring more power
than the charger can
deliver in 48 hours.
15
SOLUTION
Check for poor connection to
battery and frame. Make sure
connection points are clean.
Rock clips back and forth for a
better connection.
Correct connection.
Replace the battery or try
using a manual charger to
bring above one volt.
Make sure nothing is touching
the control panel, then unplug
the unit and plug it in again.
Reset the charger by
unplugging it. Select the
desired CHARGE RATE and
BATTERY TYPE again, if
necessary.

Advertisement

Chapters

Table of Contents
loading

Table of Contents