Sanyo PLCXL51 Owner's Manual page 52

Chapter 6 Basic setting and operation
2. Select either "Manual" or "DHCP" from IP configuration pull
down menu. When "DHCP" is selected, IP address, Subnet
mask, Default Gateway, DNS are automatically configured by
DHCP function. Only the DNS address allows you to set up
manually if the DNS address information is not provided on
your DHCP server. When selecting "Manual", configure all the
items manually. For further information, contact your network
administrator. The address must be entered as 4 number
groups separated by a dot like [192.168.001.101].
3. Af te r co m p l e t i n g t h e n e t wo r k co n f i g u rat i o n , p re s s
Regist button to register the network information. The
Simple(Wireless) setting is fixed, which cannot be changed
from factory default value.
4. To apply the setting, press Set button. The network of the projector starts re-booting and applies the
setting. It takes about 20 seconds to complete. Close the web browser and access to the login page
again in 20 seconds.
On the screen of the projector, the "Please wait... " message will appear and switching operation will
start. Switching will take a while and after completing the operation, the "Ready for use" message will
appear. During the switching period, the projector cannot be operated.
When you use LAN4(wireless) or LAN5(Wireless), the setting items of page [2] and [3] are activated
and you can setup Wireless LAN setting and Security setting. See the item " Configuring Wireless LAN
Setting and Security Setting" for further setting.
52