Advertisement
2610041926 10-15 WC18CV_WC18C 10/7/15 9:07 AM Page 6
The Bosch power supply and wireless
charger must be used in conjunction with
the wireless charging holster WC18H.
Add/change Holster Inserts
The holster is compatible with the following
Bosch 18V Drill/Drivers and Impact Drivers
through the use of specially-designed inserts
(see Fig. 2a). When purchased as a toolkit, the
correct insert is shipped with the toolkit. When
purchased as a starter kit, the correct insert
should be selected from the Holster Insert
Compatibility table and installed according to the
instructions below.
Holster-Compatible Tool
DDH181
HDH181
DDH181X
HDH181X
DDS181
DDS181A
HDS181
HDS181A
DDS182
HDS182
DDS183
HDS183
25618
IDH182
WC18H Holster Assembly
Note: Refer to Fig. 2a.
1. Remove Screw/Nut 1.
2. Loosen the (2x) Screw 2.
3. Remove installed inserts, pinching the bottom
of inserts and pulling them from the holster.
4. Position new inserts, matching left and right
sides appropriately. Grooves in inserts and
holster should align.
5. Retighten (2x) Screw 2.
6. Reattach and tighten Screw/Nut 1.
Installing the Charger into the Holster
1. Slide the charger into the tray. (Fig. 2b) Be
sure that the charger is fully inserted into the
Insert
tray and that the power cord is routed out the
back of the tray.
2. Slide the tray into the holster.
1
WCBAT612-WCBAT615 batteries, slide the
tray guide rails into the upper tray guide slot.
For WCBAT620-WCBAT625 batteries, slide
the tray guide rails into the lower tray guide
slot. Be sure to route the power cord through
the back of the holster. (Fig. 2a)
Removing the Charger from the Holster
2
1. Unplug the power cord from power supply
2. Remove the tray from the holster (Fig. 2a)
3. Remove the charger from the tray by first
pulling charger up, then out of the tray (Fig.
3
2b).
4
-6-
For
Advertisement
