Table of Contents
Advertisement
IRQ 5
IRQ 10
These options specify the bus that the named interrupt request lines (IRQs) are used on. These
options allow you to specify IRQs for use by legacy ISA adapter cards.
Assign IRQ to PCI VGA Card : This setting specify the requirement of IRQ dedicated for PCI
VGA Card. The default setting is Yes .
To continue the 'Advanced CMOS Setup', please move your cursor downwards to seek for other
options.
PCI Slot3 IRQ Priority
PCI Slot4 IRQ Priority
DMA Channel 0
DMA Channel 1
DMA Channel 3
DMA Channel 5
DMA Channel 6
DMA Channel 7
IRQ3
IRQ4
IRQ5
IRQ7
IRQ9
IRQ10
IRQ11
IRQ12
IRQ14
IRQ15
Reserved Memory Size
Reserved Memory Address
PCI Slot1 / Slot2 / Slot3 / Slot4 IRQ Priority : Without prior definition from the system board
designer, the default settings of these fields are Auto . These options determine if AMIBIOS should
remove an IRQ from the pool of available IRQs passed to BIOS configurable devices. The available
IRQ pool is determined by reading the ESCD NVRAM. If more IRQs must be removed from the pool,
the end user can use these PCI/PnP Setup options to remove the IRQ by assigning the option to the
ISA/EISA setting. Onboard I/O is configurable by AMIBIOS. The IRQs used by onboard I/O are
configured as PCI/PnP .
AMI BIOS SETUP – PCI / PLUG AND PLAY SETUP
© 1997 American Megatrends, Inc. All Rights Reserved
AP-545V/43
Auto
Auto
PnP
PnP
PnP
PnP
PnP
PnP
ISA/EISA
ISA/EISA
PCI/PnP
ISA/EISA
PCI/PnP
PCI/PnP
PCI/PnP
PCI/PnP
PCI/PnP
PCI/PnP
Disabled
C8000
AMI BIOS SETUP
Available Options
4 Disabled
16k
32k
64k
-¯
ESC : Exit
PgUp/PgDn :
Modify
F2/F3 : Color
: Sel
Advertisement
Table of Contents
