The contents in this publication have been thoroughly checked and considered accurate. The publisher and manufacturer of this product, Lanner Electronics, is not responsible for any violation of patents or other rights of third parties resulting from its use. Neither does Lanner Electronics assume any responsibility for any inaccuracies contained in this manual, nor make any commitment to keep the information in this document up-to-date.
Always follow basic safety precautions to reduce the risk of fire, electrical shock and injury to persons. Do not apply power into FW-3600 before installation or when disconnecting this product from its original system setup. Use only the specified power adapter (output voltage: 5VDC/3A) and make sure the power adaptor’s plug matches your electrical wall outlet.
Getting Technical Assistance Should you encounter questions or problems with your FW-3600, Lanner Electronics is ready to assist you within the guidelines of our product support programs. First, check the electronic product documentation for assistance. If you still cannot find the solution to your problem,...
Introduction Figure 1 – FW-3600 Outlook The FW-3600 is a mini desktop Intel IXP based firewall platform equipped with an Intel IXP 422/425 processor. A cost-effective and fanless solution of its kind, it comes with a pre-installed Booting Code and Linux Kernel. Its onboard mini PCI slots are tested compatible with any type of WiFi 802.11g card and IPSec VPN Accelerating card.
If you find anything missing or damaged, promptly contact your dealer for assistance. EM-434 System Board EM-434 is the system board bundled with the FW-3600 firewall platform. The succeeding sections list all EM-434 related jumper settings and connector pin assignments.
1.4.2 Board Layout Figure 3 – EM-434 Jumpers and Connectors 1.4.3 Jumper Settings The onboard jumper settings of EM-434 are custom-tailored to fit the FW-3600 functionality. Changing the jumper settings may result in system malfunction or unforeseen damages. 1.4.4 Connector Pin Assignments PS4S1: 4-Pin Power Connector (Small-4P) Pin No.
FW-3600 Mini Desktop Firewall Mechanisms This section of the manual describes the mechanical and device nomenclature of FW-3600. 1.5.1 Mechanical Dimensions The illustration below identifies the physical measurements of the FW-3600. The measurement unit used is in millimeters (mm). Figure 4 – FW-3600 Chassis Dimensions (units in mm) 1.5.2 Face Panel...
Face Panel LED Status and Behavior The following table lists and explains the behavior of each LED on the FW-3600 front panel. Color Status Description When FW-3600 power is switched ON Power Green No power connected When GPIO 15 is programmed and set to a value of Status “0”...
C h a p t e r 2 EM-434 Image Download This chapter explains the procedures when configuring the FW-3600, including its OS and applications. The following sections and each procedure are highly required to achieve your technical requirements. Pre-installed Linux Software The pre-installed Linux Kernel in the FW-3600 has the following details: Version No.: 02042004...
Boot-up Conditions Once the FW-3600 console port is connected to a console PC, there will be two choices available mid-way during the FW-3600 system boot up: 1 Enter OS (default): “1” allows access into FW-3600 OS and runs the firewall 2 Enter Redboot: “2”...
Page 18
The displayed screen will show the figure below after selecting option “2”.
2.3.1 Hardware Requisites Before executing any command line, a JTAG cable must connected from the EM-434 control board of FW-3600 to the parallel port of the console PC. To do this, follow the steps below. Remove the cover of FW-3600.
Note: RTL8305SB Ethernet port: LANA3. The bundled Linux Kernel of FW-3600 is an open source architecture. This section is of vital use for programmers who wish to set up the FW-3600 into a TFT server. Downloading of Linux and Ramdisk are required when you intend to perform the following:...
A p p e n d i x A Driver Information This appendix contains a rundown of the drivers contained in the Drivers and User’s Manual Disk. The drivers of each component are vital for programmers when developing their proprietary kernels. NOR Flash DRAM RealTek RTL8100B...
Terms and Conditions Date:2004.07.08 Warranty Policy All products are warranted against defects in materials and workmanship for a period of two years from the date of your purchase. The buyer will bear the return freight charges for goods returned for repair within the warranty period;...
Page 23
RMA Service Request Form When requesting RMA service, please fill out this RMA Service Request Form. Without this form your RMA will be REJECTED!!! RMA No: Reasons to Return: Repair(Please include failure details) Testing Purpose Company: Contact Person: Phone No. Purchased Date: Fax No.: Applied Date:...
Page 24
PEXNSD01-040709 Version 1.0 Printed and published in Taiwan...