2.2 Cpu I - Lanner electronics AP-545V Manual

2.2 CPU I

NSTALLING AND UPGRADING
To upgrade to a higher power Pentium CPU, simply remove the old CPU and install to a new one; be
sure to set the jumpers for the new CPU type and speed.
WARNING!
Disconnect the power cord from your system when you intend to work on it or you plan
to open the chassis of your IPC. Do not make connections when the power is turned
on as sensitive electronic components can be damaged by the sudden rush of power.
Please only allow experienced electronics technicians to do this job.
STATIC ELECTRICITY PRECAUTION!
Caution! Computer components are very sensitive to damage from static electric
discharge. Always ground yourself to remove static charge build-up before touching
the boards in the computer.
electronic components on the anti-static pad for static-dissipation or in a
static-shielded bag when they are not in the chassis.
2.3 J S
UMPER ETTING
In order to select the operation modes of your system, configure and set the jumpers on the your SBC
to match the need of your application.
is placed over the jumper pins as designated by the required configuration as listed in this section.
jumper is said to be " on " or " 1-2 " when the black cap has been placed on two of its pins, as show
in the figure below:
A pair of needle-nose pliers is recommended when working with jumpers. If you have any doubts
about the best hardware configuration for your application, contact your local sales representative
before you make any changes.
connections.
Use a grounding wrist strap at all time.
O
VERVIEW
To set a jumper, a black plastic cap containing metal contacts
In general, you simply need a standard cable to make most
AP-545V/5
JUMPER SETTING AND CONNECTORS
Place all
A