Choosing The Correct Adaptor - Sanyo DMP-692 Instruction Manual

Choosing The Correct Adaptor

When connecting an iPod / iPhone to this iPod Dock, pleaase ensure
that the correct adaptor plate is used. FAILURE TO DO SO MAY
RESULT IN DAMAGE TO THE iPod / iPhone.
This iPod Dock comes with 6 removable dock adaptors. Using the correct adaptor
ensures the proper fit for your iPod / iPhone and helps to reduce the stress on the
connector when operating the iPod / iPhone.
To place a dock adaptor:
1. Refer to the compatibility table below and select the correct
dock adaptor for the iPod / iPhone.
2. Place the proper adaptor into the dock and press it into
position. The adaptor will only go in one way. The iPod
dock connector should fit through the opening in the
bottom of the adaptor.
3. Carefully align and then gently insert the iPod / iPhone into
the dock. (The iPod / iPhone must not be in a case or "SKIN")
4. To remove/replace a dock adaptor, first remove the iPod / iPhone,
then grip the adaptor and pull gently upwards.
Charging your iPod / iPhone
Note: Please make sure you are using the correct insert for your iPod / iPhone and that it is
properly docked into this unit.
FAILURE TO DO SO MAY DAMAGE THE iPod / iPhone.
When an iPod / iPhone is inserted into the dock, it will go to standby mode then turn off. While
the iPod / iPhone is docked in the system, it will recharge (until fully charged). Please note that
older 3rd generation iPod cannot be charged by this unit.
NOTE: In order to avoid interfering with the reception, the iPod / iPhone will not be charged in
the TUNER mode(FM / AM).
iPod / iPhone OPERATION
24