Setting The Clock - Sanyo DMP-692 Instruction Manual

Setting The Clock

When the system is connected to the 120V 60Hz AC Outlet for
the first time, "AM 12:00" will flash on the display.
Important: Do not press the STANDBY/ON button to turn the system 'On'. The clock can
only be set when the system is in the Standby Mode.
1.) Touch and hold the TIME SET control on the top panel, or depress and hold the TIME
SET button on the remote control until only the "Hour" digits are flashing.
2.) Touch the TUNE/SKIP
press the /
correct hour. Be sure to observe the AM/PM indicators to
confirm that the hour is set correctly.
3.) Touch the TIME SET button on the top panel or depress the
TIME SET button on the remote control then the "Minute"
digits are flashing. Press the
remote control or touch the TUNE/SKIP
top panel to set the correct minute.
4.) When the correct time appears on the display, touch the
TIME SET button on the top panel or press the TIME SET
button on the remote control once more. The display stops
flashing and the clock begins to run.
SETTING & BASIC OPERATION
/ Buttons on the top panel, or
Buttons on the remote control to set the
/ buttons on the
/ buttons on the
14