Avery Dennison ALS 306 Installation Manual page 42

Label dispenser
Hide thumbs Also See for ALS 306:
Table of Contents

Advertisement

2
I
NSTALLATION
2.3 C
ONNECTING THE SENSORS
Positioning the sensor holder:
The sensor holder be varied in a wide range on the hol-
ding rods. The most favorable position can be found as
follows:
– Label web is in stop position (position just after dis-
pensing a label).
Push the sensor holder over a label gap and fix it
there.
– In this position should be possibly few labels bet-
ween dispensing edge and (capacitive) sensor.
– Fine adjustment of the stop position is done in the
same way as with the standard label sensor.
Leuze sensor setting
:
Remove label material from the sensor fork.
Turn potentiometer [72B] to the right, until a light
click is audible (= max. sensitivity). Turn the
½
potentiometer
turn to the left.
Turn potentiometer [72D] until both LEDs [72C]
shine equally bright (= base adjustment).
Move the label web through the sensor fork and
watch the switching output LED.
– The LED [72C] must shine in label gaps.
If case of insufficient switching behaviour, change
the sensitivity setting.
After increasing the sensitivity setting, the base
adjustment must be repeated.
– See
www.leuze.de
Di-Soric sensor setting:
Insert label material into the sensor fork.
– The label material must lie on the bottom fork arm
[73D].
Press the button [73C], until the mode LED [73B,
yellow] lights up (approx. 2 s).
– The mode LED starts to flash quickly for approx.
2-4 s.
During the mode LED flashes, move at least two
labels through the sensor fork.
Service and mode LEDs are flashing...
– 2x: The auto-teach procedure has been concluded
sucessfully. The service LED lights green.
– 4x: The label was not detected optimally, the best
possible switching point will be set. The service LED
lights red.
A
B
[72] Capacitive label sensor LEUZE GK14/24
A LED display switching output
B Set screw sensitivity
C LED display base adjustment
D Set screw base adjustment
A
D
[73] Capacitive label sensor di-soric KSSTI 1000/80 FG3LK-
AIBS
A Service LED (grün/rot)
B Mode LED (gelb)
C Auto-teach button
D Bottom fork arm
42
C D
B
C
ALS
306
309

Advertisement

Table of Contents
loading

This manual is also suitable for:

Als 309

Table of Contents