Connecting To An Amplifier With Dolby Pro Logic Decoder (Example 6); Power Supply; For Safe And Efficient Operation - Sanyo DVD-SL33 Instruction Manual

Connecting to an Amplifier with Dolby Pro Logic Decoder (Example 6)

*Audio cable
(not supplied)
To AUDIO OUT jacks
Note:
Please refer to your amplifier instruction manual.

Power Supply

Connect the power cord to a 120VAC 60Hz outlet. This unit is
equipped with a polarized plug. If you have difficulty inserting the
plug, turn it over and reinsert it. If the unit will not be used for a
long time, disconnect the AC plug from AC outlet.
Notes:
• Before plugging the power cord into an AC outlet, make sure
that all the connections have been made.
• The unit is not disconnected from the AC power unless the
power cord is unplugged from the AC outlet.

FOR SAFE AND EFFICIENT OPERATION

• Do not damage the power cord.
• When not in use, disconnect the power cord from the outlet.
Grasp the plug, not the cord, when disconnecting the unit.
• If water should enter the unit, electrical shock or a malfunc-
tion may result. Use in an area where there is low humidity
and little dust.
• Do not disassemble or alter the unit in any way.
• Do not use the unit in areas where extremes in temperature
occur (below 40˚F(5˚C) or exceeding 95˚F(35˚C)), or where
it may be exposed to direct sunlight.
• Because of the DVD video player extremely low noise and
wide dynamic range, there is a tendency to set the volume
on the amplifier higher than necessary. Doing so may pro-
duce an excessively high output from the amplifier which can
cause damage to your speakers. Please be careful in this
regard.
• Sudden changes in the surrounding temperature can cause
dew to form on the optical pickup lens inside the unit. Under
this condition the unit may be unable to operate properly. If
this should occur, remove the disc and allow the player to
adjust to the surrounding temperature.
DVD-SL33/CA(English) 14
Amplifier with Dolby Pro Logic Decoder
To AUDIO INPUT jacks
Front left
speaker
Surround left
speaker
-E13-
Center
speaker
Front right
speaker
Surround right
speaker
*Please consult your local audio/video dealer.
CAUTION:
When connecting the DVD video player, follow the installa-
tion instruction in "IMPORTANT SAFETY INSTRUCTIONS"
on page E2.
CAUTION:
TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE
OF PLUG TO WIDE SLOT, FULLY INSERT.
ATTENTION:
POUR ÉVITER LES CHOC ÉLECTRIQUES, INTRODUIRE
LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE
CORRESPONDANTE DE LA PRISE ET POUSSER
JUSQU'AU FOND.
• When carrying the unit, be sure to remove a disc which
may be inside and turn the power off. Then unplug the
power cord from the AC outlet after 10 seconds. Carry-
ing the unit with a disc inside may damage the disc and/
or the unit.
• The unit is automatically set to the Screen Saver mode after
approximately 15 minutes have elapsed under the stop or
pause mode.
• The unit is automatically set to the standby mode after ap-
proximately 30 minutes have elapsed under the complete
stop mode.
• Do not install this equipment in confined space, such as a
book case or built in cabinet.
Press [ q ] (or [OPEN/CLOSE] on the remote control) when
closing the disc tray. Do not push the disc tray.
13/06/2003, 10:06
Subwoofer