Connecting To An Amplifier With Dolby Pro Logic Decoder (Example 6); Power Supply; For Safe And Efficient Operation - Sanyo DWM-390 Instruction Manual

Connecting to an Amplifier with Dolby Pro Logic Decoder (Example 6)

*Audio cable
(not supplied)
To AUDIO OUT jacks
COMPONENT VIDEO OUT
Y P P
B R
VIDEO OUT
SELECT
S
R L
S-VIDEO OUT
COMPONENT
AUDIO OUT VIDEO OUT
Note:
Please refer to your amplifier instruction manual.

Power Supply

Connect the power cord to a 120VAC 60Hz outlet. This unit is
equipped with a polarized plug. If you have difficulty inserting the
plug, turn it over and reinsert it. If the unit will not be used for a
long time, disconnect the AC plug from the AC outlet.
Notes:
• Before plugging the power cord into an AC outlet, make sure
that all the connections have been made.
• The unit is not disconnected from the AC power unless the
power cord is unplugged from the AC outlet.

FOR SAFE AND EFFICIENT OPERATION

• Do not damage the power cord.
• When not in use, disconnect the power cord from the outlet.
Grasp the plug, not the cord, when disconnecting the unit.
• If water should enter the unit, electrical shock or a malfunction
may result. Use in an area where there is low humidity and
little dust.
• Do not disassemble or alter the unit in any way.
• Do not use the unit in areas where extremes in temperature
occur (below 40 F (5 C) or exceeding 95 F (35 C)), or where
it may be exposed to direct sunlight.
• Because of the DVD video player extremely low noise and
wide dynamic range, there is a tendency to set the volume on
the amplifier higher than necessary. Doing so may produce
an excessively high output from the amplifier which can
cause damage to your speakers. Please be careful in this
regard.
• Sudden changes in the surrounding temperature can cause
dew to form on the optical pickup lens inside the unit. Under
this condition the unit may be unable to operate properly. If
this should occur, remove the disc and allow the unit to adjust
to the surrounding temperature.
To AUDIO INPUT jacks
Front left
speaker
Surround left
OPT.
DIGITAL
OUT
speaker
Amplifier with Dolby Pro Logic Decoder
Center
speaker
*Please consult your local audio/video dealer.
CAUTION:
When connecting the DVD video player, follow the installation
instructions in "IMPORTANT SAFETY INSTRUCTIONS" on
page E2.
• When carrying the unit, be sure to remove a disc which
may be inside and turn the power off. Then unplug the
power cord from the AC outlet after 10 seconds. Carrying
the unit with a disc inside may damage the disc and/or
the unit.
• The unit is automatically set to the Screen Saver mode after
approximately 15 minutes have elapsed under the stop or
pause mode.
• The unit is automatically set to the standby mode after
approximately 30 minutes have elapsed under the complete
stop mode.
Press [q] (or [OPEN/CLOSE] on the remote control) when
closing the disc tray. Do not push the disc tray.
-E13-
Front right
speaker
Subwoofer
Surround right
speaker
Need help? Call
1-800-813-3435