Related Manuals for A.J.Antunes roundup MS-355
Summary of Contents for A.J.Antunes roundup MS-355
- Page 1 MANUFACTURING NUMBERS: 9100480 9100482 9100483 9100486 MIRACLE STEAMER Models MS-355 P/N 1010456 Rev. C 08/12 Owner s Manual ’...
-
Page 2: Table Of Contents
MIRACLE STEAMER TABLE OF CONTENTS Owner Information .............2 Operation ..............8 General ..............2 Operating Instructions ..........8 Warranty Information ..........2 Programming .............8 Service/Technical Assistance ........3 Hi-Limit Reset Button ..........10 Model Designation .............3 Status Indicator LEDs ..........10 Important Safety Information ........3 Fault Codes .............10 Specifications .............5 Maintenance .............. -
Page 3: Service/Technical Assistance
MIRACLE STEAMER OWNER INFORMATION (continued) Service/Technical Assistance Use only genuine Roundup replacement parts in this If you experience any problems with the installation or unit. Use of replacement parts other than those sup- operation of your unit, contact your Authorized Service plied by the manufacturer will void the warranty. - Page 4 MIRACLE STEAMER IMPORTANT SAFETY INFORMATION (continued) In addition to the warnings and cautions in this manual, • This equipment is to be installed to com- use the following guidelines to safely operate the unit. ply with the basic plumbing code of the Building Officials and Code Administrators, • Read all instructions before using equipment.
-
Page 5: Specifications
MIRACLE STEAMER SPECIFICATIONS Electrical Ratings Electrical Cord & Plug Configurations Model and Voltage Watts Amps Hertz Model and Description Configuration Mfg. No. Mfg. No. MS-355 3300 15.9 50/60 MS-355CV 6-20P, 20 Amp., 9100480 9100480 250 VAC., 9100486 Non–locking MS-355 1800 15.0 50/60 (Assembly... -
Page 6: Installation
MIRACLE STEAMER INSTALLATION Unpacking 1. Remove the unit and all packing materials from Drawer the shipping carton. 2. The unit should come with the items listed below: Drip Pan • Owner’s Manual • Authorized Service Agency Directory • Drawer Assembly NOTE: If any parts are missing or damaged, con- tact A.J. -
Page 7: Electrical
MIRACLE STEAMER INSTALLATION (continued) WARNING WARNING Electrical THIS APPLIANCE MUST BE THIS APPLIANCE MUST BE 1. Set the unit on a sturdy, level table or work surface. EARTHED (GROUNDED) EARTHED (GROUNDED) THIS UNIT IS DESIGNED TO 2. Ensure that the line voltage corresponds to the OPERATE ON 120 VOLTS 120 VAC ONLY. -
Page 8: Operation
MIRACLE STEAMER OPERATION Programming Ready Light CYC (Total Cycle Time) refers to the total pro- grammed steam time set for the product. READY Message SHO (Shot Interval Time) is the time set between Display shots of steam during a complete cycle. SINGLE SHOT Start/Stop H2O (Steam Shot Time) refers to the water volume... - Page 9 MIRACLE STEAMER OPERATION (continued) 6. Press and release and then press ▲ or ▼ to change the SHO in seconds (Figure 4, Item E). READY READY 7. Press and release again and press ▲ or ▼ to 1500 change the SHO in minutes (Figure 4, Item F). SINGLE SHOT SINGLE SHOT 8. Press and release and “H2O”...
-
Page 10: Hi-Limit Reset Button
MIRACLE STEAMER OPERATION (continued) Hi-Limit Reset Button A hi-limit thermostat turns off electrical power to the Hi-Limit Reset Button steam generator if it overheats. To reset this thermo- stat, allow approximately 45 minutes for the unit to cool Power Cord down, remove the black cap, and then press the black reset button located on the rear of the unit (Figure 5). -
Page 11: Maintenance
MIRACLE STEAMER MAINTENANCE Daily WARNING Turn the power off, unplug the power cord, and 1. Turn the power off, unplug the power cord, and allow the unit to cool down before performing any allow the unit to cool down before proceeding. service or maintenance. -
Page 12: Monthly
MIRACLE STEAMER MAINTENANCE (continued) Monthly The Miracle Steamer utilizes an open steam generator. Wing Nut Water sprayed onto the Generator surface flashes into steam immediately, but the minerals in the water do not Generator steam, they stay on the Generator surface. A small Cover amount of calcium/mineral deposits are needed for proper operation, but a buildup of excessive calcium/... -
Page 13: Troubleshooting
MIRACLE STEAMER TROUBLESHOOTING WARNING To avoid possible personal injury and/or damage to the unit, inspection, test and repair of electrical equip- ment should be performed by qualified service personnel. The unit should be unplugged when servicing, except when electrical tests are required. Problem Possible Cause Corrective Action Control Display is blank (power is on The power cord is not correctly Plug the power cord into the appro- but indicator light is off). - Page 14 MIRACLE STEAMER TROUBLESHOOTING (continued) Problem Possible Cause Corrective Action Unit heats but there Filter Strainer is restricted. Check and clean the Filter Strainer as described in is little or no steam the Maintenance section of this manual. produced Unit is not being cleaned properly Clean unit daily and monthly as described in the (daily/monthly).
-
Page 15: Replacement Parts
MIRACLE STEAMER REPLACEMENT PARTS P/N 1010456 Rev. C 08/12 A.J. Antunes & Co. - Page 16 MIRACLE STEAMER REPLACEMENT PARTS (continued) 44 62 P/N 1010456 Rev. C 08/12 A.J. Antunes & Co.
- Page 17 MIRACLE STEAMER REPLACEMENT PARTS (continued) Item Part No. Description Qty. Item Part No. Description Qty. 0011314 Steam Vent Assy. 42 300P102* Nut, Speed, “U”, #8-32 7000237 Top Cover Assy. (Incl. #73-77) 43 304P105* Nut, Hex, KEPS, #4-40, Zinc 44 306P101* Nut, Hex, #6-32 0011413 Liner Assy.
-
Page 18: Wiring Diagrams
MIRACLE STEAMER WIRING DIAGRAMS *NOTE: For 208-240 VAC units, the two primary coils are wired in series with one another. For 120 VAC units, the two primary coils are wired in parallel with one another. P/N 1010456 Rev. C 08/12 A.J. -
Page 19: Notes
MIRACLE STEAMER NOTES P/N 1010456 Rev. C 08/12 A.J. Antunes & Co. -
Page 20: Limited Warranty
LIMITED WARRANTY Equipment manufactured by Roundup Food Equipment Division of A.J. Antunes & Co. has been con- structed of the finest materials available and manufactured to high quality standards. These units are warranted to be free from electrical and mechanical defects for a period of one (1) year from date of purchase under normal use and service, and when installed in accordance with manufacturer’s recom- mendations.
Need help?
Do you have a question about the roundup MS-355 and is the answer not in the manual?
Questions and answers