A.J.Antunes roundup MS-150 Owner's Manual

A.J.Antunes roundup MS-150 Owner's Manual

Miracle steamer

Advertisement

Quick Links

READ Y
PROGRA M START/S
TOP
DOWN
UP
POW ER
MS-150
miracle steamer
owner's manual
Manufacturing Numbers:
9100421, 9100429
www.ajantunes.com
P/N 1010881 Rev. G 03/12

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the roundup MS-150 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for A.J.Antunes roundup MS-150

  • Page 1 READ Y PROGRA M START/S DOWN POW ER MS-150 miracle steamer owner’s manual Manufacturing Numbers: 9100421, 9100429 www.ajantunes.com P/N 1010881 Rev. G 03/12...
  • Page 2: Table Of Contents

    IMportaNt WarranTy inforMaTion Model Number A.J. Antunes & Co. reserves the right to change specifications and product Please read the full text of the Limited Warranty in this manual. design without notice. Such revisions do...
  • Page 3: Important Safety Information

    iMporTanT SafeTy WarninGS inforMaTion • The following tips are recommended Be advised of the following warnings when operating and performing maintenance on for maintenance of your stainless steel Use the following guidelines for safe opera- equipment: this unit. tion of the unit. • Always use soft, damp cloth for • If the supply cord is damaged, it must • Read all instructions before using...
  • Page 4: Specifications

    SpecificaTionS Model & agency approvals Mfg. No. MS-150 9100421 9100429 Width Depth Height Model No. MS-150 21" 21 3/8" 10 1/4" 9100421 (533 mm) (543 mm) (260 mm) 9100429 Model & Plug Volts Watts Amps Hertz Mfg. No. Description IEC-309 16 Amp., MS-150 3300 14.4...
  • Page 5: Installation

    All electrical connections must be in accor- • Spatula Assembly dance with local electrical codes and any other NotE: If any parts are missing or dam- applicable codes. aged, contact a.J. antunes IMMEDIatELY Spatula Spatula Liner at 1-800-253-2991 or 1-630-784-1000. elecTrical Figure 1.
  • Page 6: Operating Instructions

    proGraMMinG IMportaNt: Miracle Steamers are factory programmed for the following recom- ready CYC (total Cycle time) refers to the total mended settings: Light programmed steam time set for the product. READY • Total Cycle Time (CYC) = 15 min., 00 secs.
  • Page 7: Generator Temperature

    CaUtIoN Steam Vent Spatula 4 0 0 F Do not use a sanitizing solution or abrasive materials. The use of these may cause dam- age to the stainless steel finish. CaUtIoN Cover DOWN PROGRAM START/STOP If a chemical cleaner is used, be sure it is Figure 5.
  • Page 8: Monthly Maintenance

    MonThly MainTenance Water tank Filter The Miracle Steamer utilizes an open steam Wing Nut Generator. Water sprayed onto the Generator surface flashes into steam immediately, Generator Filter Stem but the minerals in the water stay on the Cover Generator surface. A small amount of calcium/ tank Door mineral deposits are needed for proper opera- Diffuser...
  • Page 9: Troubleshooting

    TroubleShooTinG WarNING To avoid possible personal injury and/or damage to the unit, inspection, test, and repair of electrical equipment should be performed by qualified service personnel. The unit should be unplugged when servicing, except when electrical tests are required. Use extreme care during electrical circuit tests.
  • Page 10 TroubleShooTinG (continued) problem possible Cause Corrective action Unit heats but there is little or no Filter Strainer is restricted. Check and clean the Filter Strainer as described in steam produced the Maintenance section of this manual. Unit is not being cleaned properly (daily/monthly). Clean unit daily and monthly as described in the and/or Maintenance section of this manual.
  • Page 11: Wiring Diagram

    WirinG DiaGraM P/N 1010881 Rev. F 03/12...
  • Page 12: Replacement Parts

    replaceMenT parTS P/N 1010881 Rev. F 03/12...
  • Page 13 replaceMenT parTS (continued) Item part No. Description Qty. Item part No. Description Qty. Item part No. Description Qty. 0010159 Filter Assy., Water Tank 1 29 0503429 Support, Generator 54 306P134* Screw, Machine, Upper. #6-32 x 3/8" 7000370 Relay 30 7000849 Silicon Tube Kit, 4060374 Ground Lug, Copper 1 55 308P103* Screw, Machine, Water Pump...
  • Page 14 replaceMenT parTS (continued) 49 63 P/N 1010881 Rev. F 03/12...
  • Page 15 replaceMenT parTS (continued) Item part No. Description Qty. Item part No. Description Qty. Item part No. Description Qty. 0010159 Filter Assy., Water Tank 1 29 0503429 Support, Generator 54 306P134* Screw, Machine, Upper. #6-32 x 3/8" 7000370 Relay 30 7000849 Silicon Tube Kit, 4060374 Ground Lug, Copper 1 55 308P103* Screw, Machine, Water Pump...
  • Page 16: Limited Warranty

    WarranTy Equipment manufactured by Roundup Food Equipment Division of A.J. Antunes & Co. has been constructed of the finest materi- als available and manufactured to high quality standards. These units are warranted to be free from electrical and mechanical defects for a period of one (1) year from date of purchase under normal use and service, and when installed in accordance with manufacturer’s recommendations.

This manual is also suitable for:

Roundup ms-250

Table of Contents