Fault/Error Codes - Whirlpool W10254428A Manual

FOR SERVICE TECHNICIAN'S USE ONLY
FAULT/ERROR CODES — The fault codes below may be indicated under various
conditions and can be accessed through Service Diagnostics.
Display EXPLANATION AND RECOMMENDED PROCEDURE
SUDS SUDS DETECTED
Fault is displayed when Suds prevent the basket from spinning up to speed or the pressure sensor detects
rising suds level. The main control will flush water in attempt to clear Suds. If the water flush is unable to
correct the problem, this may indicate:
Possible Causes
Verify Bulk Dispensing setting. Make sure user has selected the right type of detergent and water hardness.
F0E1 LOAD DETECTED DURING THE WASHER CLEANING CYCLE
to verify problem.
Possible Causes
F1E1 CCU ERROR
A
not working properly.
Possible Causes
A
A
See T
F1E2 MCU ERROR - MULTIPLE RESETS
error occurs during a high-speed spin, the door will remain locked for 3 minutes.
Possible Causes
T
F2E3 UNSUPPORTED CYCLE
Possible Causes
F3E1 PRESSURE SWITCH / PRESSURE SENSOR ERROR
switch is model dependent, but the procedure to detect this error does not change.
Possible Causes
T
F3E2 TEMPERATURE SENSOR ERROR
T
To
service diagnostics.
Possible Causes
T #1
F3E4 BULK PRESENCE OR LEVEL SENSOR ERROR
The Bulk sensor is not able to detect presence of the cartridge or level of the detergent. This error code
does not stop the washer from functioning and is available only in service diagnostics.
Possible Causes
T
F5E1 DOOR SWITCH ERROR
This code is generated if the door has not been open for 3 consecutive cycles, or the door switch is open
3 times. This error code is available only in service diagnostics.
Possible Causes
T
DO NOT REMOVE OR
y,
T without closing door.
DESTROY
The use of analog pressure sensor or digital pressure
. Is hose pinched, kinked, plugged, or leaking air?
.
. Verify power at outlet
.
y.
This error code is available only in
PAGE 7