3433
Control panel for sliding gate motor- single swing gate motor-barrier up to 1200watt
Code
Frequency
3433
433,92
Κατά παραγγελία
Terminal
Photocel
Codification
Switches
ΝΑΙ
ΝΑΙ
Ext.
Auto Close
ls
Button
ΝΑΙ
ΝΑΙ
Function Description
1 DECELARATION
OFF: NO decelaration
With deceleration, that starts
ON:
1sec. before the end-route of the gate and continues for
40sec. or until the terminal switches are reached. If there are
not terminal switches, the deceleration continues for 15
seconds.
2 BRAKE
OFF: No motor brake
Brake when the gate reaches the end of the route. This
ON:
function should only work with the deceleration function.
3 AUTO CLOSE FUNCTION
OFF: No auto close
Embedded auto close function. Works with the photocell.
ON:
When the gate opens and there is no access (no obstacle
detection from the photocell), the A/C time is 120 seconds (the
gate will close after 120 seconds).
obstacle detection from the photocell, then the A/C time is 10
seconds (the A/C timer counts 10 seconds after the photocell
is free and then the gate will automatically close). The second
time of A/C can be changed (follow the below instructions).
4 TERMINAL SWITCHES
NO terminal switches. In case of single swing gate or
OFF:
rolling shutter
ON:
Terminal switches. In case of sliding gate or barrier.
5 PHOTOCELL
NO photocells.
OFF:
ON:
Photocells. The power
terminal 13&14 and COM & NC of the photocell in terminal 9
and 10
6 ADJUSTABLE DECELARATION
OFF: motors up to 800kg
ΟΝ: motors above 800kg
7 MOTOR POLARITY CHANGE
The first move of the motor after power reset needs
OFF/ON:
to be opening, when auto close is disabled. If not, switch the
dipswitch 7 to the opposite position.
8 SAFETY EDGE
OFF: Safety edge disabled
ON: Safety edge enabled. When activated the door stops and
moves back 10 cm.
Proedrou Drakaki 11 ,173 41Agios Dimitrios
Tel: 210 9850 244, Fax: 210 9823 264
www.profelmnet.com
Pedestrian
Light
Motor
Slow
230V
torque
move
ΝΑΙ
ΝΑΙ
ΝΑΙ
If there is access and
supply of the photocell 24VAC in
move
Memory
ΝΑΙ
300