Table of Contents
Advertisement
MiniPCIeCAN-II
MiniPCIe Interface CAN Card User Manual
User Manual
When the software buffer is full, transfer it to the file (CSV format) in the hard disk, and
clear the software buffer. The message file names can be automatically numbered
sequentially. Enable this function before starting. Note that the save location cannot be
specified in the C drive. Otherwise, saving may fail. When you click Stop Saving, the
transfer will not be performed, as shown in Figure 4.18.
Figure 4.18 Saving
4.2.5 DBC Decoding and Display by ID
If you click , the DBC interface appears. You can import the required DBC file for
frame decoding (the decoding is displayed at the bottom of the interface. J1939 decoding
is included by default). Or, use this interface to display CAN frames by ID classification,
that is, "ID fixed, data changes". Data segments with changes will be marked in red. See
Figure 4.19.
Figure 4.19 DBC protocol analysis
4.2.6 Bus Utilization
Click to display the bus utilization interface. The current bus utilization and frame traffic
can be monitored in real time. The refresh time can be adjusted to adjust the display
speed. See Figure 4.20.
©2021 Guangzhou ZLG Microelectronics Technology Corp.,Ltd.
18
Advertisement
Table of Contents
