Advertisement
5. ASSEMBLY
Unpack the product and check contents against the attached contents diagram prior to assembly. Should there be any damaged or
missing parts contact you supplier immediately.
5.1.
TABLE SUPPORT ASSEMBLY
5.1.1.
Take the 2 threaded stubs from the two part connector (fig 1 - N) and insert one each into hole at either end of leg brace (fig 1 - A).
5.1.2.
Rotate the screwdriver end slot so it is parallel to the longer edge of leg brace.
5.1.3.
Repeat for other leg brace (fig 1 - A).
5.1.4.
Attach left hand end frame (fig 2 - B) to cross brace (fig 2- A) with two part connector socket cap bolt (fig 2 - N) and washer
(fig 2 - Q) and tighten with allen key (R).
5.1.5.
Repeat for right hand end frame (fig 2 - C).
NOTE: DO NOT fully tighten
5.1.6.
Position shelf (fig 3 - D) into the slot in leg brace (fig 3 - A) and between end frames (fig 2 - B & C).
5.1.7.
Position the other leg brace (fig 4 - A) slot onto the shelf with two part connector socket cap bolt (fig 4 - N) and washer
(fig 4 - Q) and tighten with allen key.
5.1.8.
Ensure that the table support is flat and square before fully tightening the two part connector socket cap bolts (N).
5.2.
ATTACHING THE BENCH TOP
5.2.1.
Place the bench top (fig 5 - F) face down onto some protective material (e.g. packaging cardboard).
5.2.2.
Attach the draw runners (fig 5 - E) with the screws (fig 5 - P) into the pre-drilled holes in the bench top.
NOTE: Ensure that the dowel pins are to placed to the front of the bench and that the draw runners are facing inwards.
5.2.3.
Seeking assistance from another person turn the table support assembly upside down and locate into place onto the bench top
and secure into the pre-drilled holes with hex head screws (fig 5 - O) and washers (fig 5 - Q).
5.2.4.
Again seeking assistance from another person turn the bench assembly back over onto its support frame.
5.3.
DRAWER ASSEMBLY
5.3.1.
Place the drawer sides (fig 6 - H) on a flat surface, with the dowel pins facing downwards.
NOTE: The drawer sides are handed.
5.3.2.
Attach the drawer joining plates and screws (fig 6 - S) into the pre-drilled holes.
5.3.3.
Attach the drawer back (fig 7 - J) to the drawer sides. Ensure that the slots are aligned on the inner faces.
5.3.4.
Slide the drawer bottom (fig 6 - I) into the slots on the drawer sides and the slot in the drawer back and push home.
5.3.5.
Place the drawer front (fig 8 - G) with the pre-drilled holes facing upwards onto a flat surface.
5.3.6.
Position the part assembled drawer so that the drawer joining plates align with the pre-drilled holes and secure with the remaining
screws (fig 8 - S).
5.3.7.
Place the assembled drawer onto the draw runners and slide into position.
© Jack Sealey Limited
fig.1
fig.3
Original Language Version
fig.5
AP1520.V2 Issue 1 23/04/21
fig.2
fig.4
Advertisement
