thank you for purchasing a sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
instructions
1. safety
1.1
general safety
warning! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this bench.
locate bench in a suitable working area.
9
Keep the work area clean, uncluttered and ensure there is adequate lighting.
9
warning! Use bench on level and solid ground, preferably concrete. Avoid tarmacadam since the bench may sink into the surface.
Keep the bench clean and tidy in accordance with good workshop practice.
9
Keep children and unauthorised persons away from the working area.
9
do not use the bench for any purpose other than that for which it is designed.
8
do not exceed maximum capacity of workbench.
8
do not undertake work on the bench without the work-piece being adequately secured. Use clamps or a vice (not included) to secure
8
the work-piece. Available from your Sealey dealer.
do not use the bench out of doors.
8
do not get the bench wet or use in damp or wet locations or areas where there is condensation.
8
do not clean the bench with any solvents which may damage the paint surface or the protective coating on the wooden top.
8
2. introduction
Powder coated steel panels with 40mm wood laminate top. Five drawers. open shelving for storage of larger items. Supplied flat packed.
3. sPecification
Table Size (W x d): ...........................................1372 x 508mm
Working Height: ............................................................865mm
Capacity: ........................................................................250kg
3.1.
Carefully unpack the product and check the contents against the diagram below. Should any items be missing or damaged make
immediate contact with your Sealey dealer.
A . . . . . SIde PAnel
C . . . . . BoTToM RAIl
d . . . . . ToP RAIl
e . . . . . CenTRe SUPPoRT
G. . . . . leFT SIde PAnel
© Jack Sealey limited
Heavy-duty workbencH witH 5
drawers ball bearing runners
Model no:
fig.1
H . . . . RIGHT SIde PAnel
I . . . . . SUPPoRT PAnel
J . . . . . BACK PAnel
K . . . . SHelF
Original Language Version
aP2030bb
M . . . . . dRAWeR
o . . . . . CoRneR BRACe
P . . . . . Wooden ToP
Q. . . . . leFT SIde RUnneR U . . . . .HeX HeAd SCReW 5/8"
R . . . . .RIGHT Slde RUnneR
S. . . . . SCReW SelF TAPPInG SCReW
T . . . . . AdJUSTABle leG leVelleR
AP2030BB Issue 2 (HF) 26/06/18