Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS,
WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED.
FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY, AND WILL INVALIDATE THE WARRANTY. PLEASE
KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
1.
SAFETY INSTRUCTIONS
1.1
GENERAL SAFETY
WARNING! Ensure Health & Safety, local authority, and general workshop practice
regulations are adhered to when using this cabinet.
WARNING! Use caution when handling and assembling the metal components.
The metal may have sharp edges or corners, the use of protective gloves is recommended.
Locate cabinet in a suitable working area and secure to a wall with suitable fasteners.
Keep the work area clean, uncluttered and ensure there is adequate lighting.
Keep the cabinet clean and tidy in accordance with good workshop practice.
Keep children and unauthorised persons away from the working area.
DO NOT climb, step or stand on the cabinet shelves.
DO NOT use the cabinet for any purpose other than that for which it is designed.
DO NOT use in damp work areas.
WARNING! The warnings, cautions and instructions referred to in this instruction manual
cannot cover all possible conditions and situations that may occur. It must be understood
that common sense and caution are factors which cannot be built into this product, but must
be applied by the operator.
2.
INTRODUCTION
Featuring two large doors, four shelves and base storage. Added security provided by cylinder
lock and supplied with two keys. All steel construction, stabilized by an inner cross member.
Overall Size (W x D x H):
3.
ASSEMBLY
3.1
CONTENTS INSPECTION
Unpack all the parts and layout on the packing
material. Visually inspect all panels to check for
transportation damage.
CONTENTS
A
BACK PANEL (RIGHT)
B
BACK PANEL (LEFT)
C
SIDE PANEL (RIGHT)
D
SIDE PANEL (LEFT)
E
CROSS MEMBER (INNER)
F
CROSS MEMBER (OUTER)
G
BOTTOM PANEL
H
TOP PANEL
I
DOOR PANEL WITH LOCK (RIGHT)
J
DOOR PANEL (LEFT)
K
SHELF
L
PLASTIC INSERT
M
HINGE INSERT
N
RUBBER BUMPER
O
SCREW (M6 X 15)
P
WASHER
Q
SHELF CLIP
R
KEY
INSTRUCTIONS FOR:
2 DOOR FLOOR CABINET
MODEL No:
915 x 457 x 1981mm
SC01
Fig.1
SC01
Issue No: 1 - 28/08/08