Related Manuals for JWA EDGAR 68430
Summary of Contents for JWA EDGAR 68430
- Page 1 ASSEMBLY INSTRUCTION EDGAR 1 DRAWER DESK ITEM CODE 68430 Imported by JWA Furniture Pty Ltd, Qld, Brisbane Australia. For any assistance with assembly or for missing parts please refer to your receipt...
-
Page 2: Before You Start
PRE-ASSEMBLY PREPARATION Before you start: 1.Choose a clean, level, spacious assembly area. Avoid hard surfaces that may damage the product 2.Take care when lifting. Product should be assembled as near as possible to the point of 3.Ensure that you have all required contents for complete assembly 4.Always read the assembly instructions carefully before beginning assembly. -
Page 3: Parts List
PARTS LIST Desktop panel Drawer panel Drawer back panel Left side panel Drawer left side panel Drawer bottom panel Right side panel Drawer right side panel Metal panel Back panel Drawer middle panel Support pipe... - Page 5 STEP 1: Load the fitting H into the metal frame P1. STEP 2: Press the plastic part on the E2 and separate E1 and E2.
- Page 6 STEP 3: The disconnected part E1 corresponds to the lead hole on panel 2 and 3 respectively, and is locked and fixed with part F; Pay attention to distinguish the opening direction of E1 parts. STEP4: Connect and lock the assembled panel 2, 3 and 4 with fitting G.
- Page 7 STEP 5: Fix the metal pipe P2 on panel 1 with fitting B. STEP 6: Connect and fix panel 1 and panel 4 with fitting A and D.
- Page 8 STEP 7: Fix the metal frame P1 in the assembled panel assembly with fitting G. STEP 8: 1) Fix panel 6 and panel 7 on panel 9 with fitting G; 2) Load panel 10 into the corresponding slot of panel 6,7 and 9; 3) Connect panel 8 to panel 9 with fitting A;...
- Page 9 STEP 9: Fix E2 on panel 6 and panel 7 with fitting F. STEP 10: Put the assembled drawers into the corresponding position of the desk.
- Page 10 STEP 11: Install a fall preventer.
- Page 11 ASSEMBLY IS COMPLETE...
- Page 12 SAFETY BRACKETS INSTRUCTIONS 1. Attach one Mounting Plate to the wall with the Large Screws. Make sure to attach the Mounting Plate into a stud. If mounting into brick or masonry you will need to acquire wall anchors. 2. Attach the second Mounting Plate to the furniture frame with the Short Screws.
- Page 13 To protect your furniture, we suggest the following: • Avoid placing your furniture in direct sunlight. • Do not place furniture directly under windows. • Do not place sharp materials (knife, fork, etc.) directly onto your furniture as sharp material may scrape and damage the finish.
Need help?
Do you have a question about the EDGAR 68430 and is the answer not in the manual?
Questions and answers