Makita LF1000 Instruction Manual page 11

2. Low table set up
► 1. Stopper hook 2. Feet 3. Hook
The feet can be folded as shown in the figure. To
fold down the tool, do as follows.
(1) Fall down the tool carefully BACKWARDS
without fail while holding it with both hands.
(2) Pull up first the stopper at the joint of left feet
toward yourself to unlock it
(3) Take the same steps for the opposite feet as
above.
(4) Use a hook to bundle these feet.
(5) Return the tool to the upright position.
Installing or removing saw blade
CAUTION:
• Always be sure that the tool is switched off and
unplugged before installing or removing the
blade.
• Use only the Makita hex wrench provided to
install or remove the blade. Failure to do so may
result in overtightening or insufficient tightening
of the hex socket bolt. This could cause an
injury.
Move up the handle in the fully raised position.
Press the shaft lock to lock the spindle, use the hex
wrench to loosen the hex socket bolt clockwise.
1
2
► 1. Hex socket bolt 2. Hex wrench 3. Shaft lock
1
2
Raise the blade guard A with its lifting lever while push-
ing the lever nearby the handle to the left. With the
blade guard A raised, remove the hex socket bolt, outer
flange and blade.
► 1. Lever 2. Lifting lever
To install the blade, mount it carefully onto the spindle,
making sure that the direction of the arrow on the sur-
face of the blade matches the direction of the arrow on
the blade case. Install the outer flange and hex socket
bolt, and then use the hex wrench to tighten the hex
socket bolt (left-handed) securely counterclockwise
while pressing the shaft lock.
2
3
► 1. Saw blade 2. Lower blade guard B
11 ENGLISH
3
1
2
1
1 2