Advertisement
TERMINAL CONNECTIONS
Connect the unit as in the diagram below.
■ EXTERNAL DIMENSIONS unit: mm (inch)
■ CONNECTION DIAGRAM
Shielded
Twisted-pair Cable
To Other
T-Link Devices
*Jumper Pin
Modular Jack
for Factory
Calibration
* When the unit is located at the end of transmission line via twisted-pair cable
(= no cross-wiring), short across the RT+ and RT– terminals with the jumper pin
(or wire) provided with the unit.
Remove the jumper pin for the one not located at the end.
Note: Use terminals T1, T2 and SD for cross-wiring.
WIRING INSTRUCTIONS
■ EURO TYPE CONNECTOR TERMINAL (T-Link)
Applicable wire size: 0.2 to 2.5 mm
Stripped length: 7 mm
50 (1.97)
T1
+
T2
−
SD
RT+
To
RT−
Installation
Terminating
Base
Resistor
MODULAR JACK
(AWG24 to 12)
2
5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
Phone: +81(6)6659-8201 Fax: +81(6)6659-8510 E-mail: info@m-system.co.jp
2–M3 SCREWS
12
(.47)
38 min.
103 (4.06)
(1.50)
LIGHTNING SURGE PROTECTION
M-System offers a series of lightning surge protectors for
protection against induced lightning surges. Please contact
M-System to choose appropriate models.
61F
EM-6635 Rev.2 P. 3 / 3
Advertisement
