Table of Contents
Advertisement
• Be sure to check dangers, which may occur due to damped floor,
ungrounded power extension cable, worn power cord or lack of safety
grounding.
When cleaning this unit, be sure to wipe with a dried cloth. If the unit is
heavily contaminated, wipe it with a soft cloth dampened with a mild
detergent solution, then wipe dry with a soft clean cloth. Do not use
chemicals such as alcohol, benzene, or thinner because a chemical reac-
tion could result permanent damaging of the cabinet surface.
On buying a product, unwrap it first and put it down on a plane or
where you want to use it. Then, you shall check if the following are
contained in the box.
- Main Body
- User's Manual
DVR
SEQUENCE
You may adjust the angle of the product as shown below.
Hang the power cord as shown in the following figure to prevent it
from being deviated when you connect it with the main body.
V
S
T
A
You can use the SSC-2000 system key board with a camera,
DVR, MULTIPLEXER, and the other equipments.
This chapter describes how to connect each equipment.
- Connect RS-485 Device through the port in the back of SSC-2000.
- You are able to install and control the camera, DVR, and multiplex-
er supporting RS-485 communication.
- Either Half Duplex or Full Duplex method is applicable for connec-
tion.
• For the Half Duplex method, use Tx +,-.
• To connect RS-485, be careful not to be confused between + and -.
Also, you shall check if the RS-485 device can support SSC-2000.
• Please refer to "RS-485 Communication Setup (GB-12)" of "Chapter 5.
Menu Setup" for RS-485 communication setup.
- Connect with SSC-2000 by using the RS-485 port on the back of
Dome Camera
• In case of connecting with Half Duplex
- Connect the Txd (+) of Dome Camera RS-485 port with the Tx (+) of
SSC-2000.
- Connect the Txd (-) of Dome Camera RS-485 port with the Tx (-) of
SSC-2000.
Advertisement
Table of Contents
