Page 7
Installation manual e-MatriX mood 800/500 RD,ST A = EA non-return valve F = Mesh filter 1 = Safety clip (11x) B = ½ or ¾ ”connector G = In-line (fine) filter 2 = Brackets (2x) fine filter C = ¼ ”1m pipe...
Installation manual e-MatriX mood 800/500 RD,ST the essential requirements of EEC Directives Dear user 2014/35/EU and 2014/30/EU. Congratulations on your purchase of a Faber fire! A Product: electric fire Opti-myst. quality product from which you will experience Model: e-MatriX mood 800/500 RD warmth and atmosphere for many years.
Page 12
Installation manual e-MatriX mood 800/500 RD,ST Installation and finishing AA = control box BB = Engine See fig. 1.5 and fig. 1.6. CC = printed circuit board A = cover strip DD = top lighting (optional) B = built-in support...
Page 13
Installation manual e-MatriX mood 800/500 RD,ST Disassemble the flexible water pipe Test mode Remove the red or blue safety clip. Do a performance test (see chapter 7) and check Push the water pipe in the coupling, hold the all water connections for leaks, before installing flange in its position and pull the water pipe out of the decoration set and the front glass.
Page 14
Installation manual e-MatriX mood 800/500 RD,ST Removing glass For replacing the glass repeat the steps in reverse order. e-MatriX mood RD Decoration set Front glass (see fig. 1.0, provide service from this side). Please note! Rotate both glass clamps clockwise.
Installation manual e-MatriX mood 800/500 RD,ST Functional test Release the clip on both sides and remove the nozzle, see fig. 8.3 and 8.4. See “Using the appliance for the first Without spilling any water, lift up the wa- time” in chapter 4 of the user manual.
Page 16
Installation manual e-MatriX mood 800/500 RD,ST Cleaning mesh filter valve is located on the right front at the bottom of Turn off the water supply. the Engine. Close the ball valves. 1. Take out the sponge. Unscrew the base and clean the filter in- 2.