ABL METERS Installation And Configuration Manual page 20

20 |
Mechanical and electrical installation
Proceed as follows to set up the energy meter:
Press and hold the enter key
1
y The password entry menu will be displayed.
NOTE
Enter the factory default password
A password is required in order to set up the energy meter. This is set as 0 by default.
If a value other than 0 is displayed, press the toggle
2
key until 0 appears on the display and hold the
enter key
y The CnGPASS menu will be displayed.
WARNING!
Changing the factory default password
If required, you can set a new password between 000 and 999 via the CnGPASS menu to protect the energy me-
ter against unauthorised access.
ƒ To change the password, briefly press the enter key
confirm the new password by holding the enter key
ƒ If you change the password, you must keep it in a safe place for reference.
NOTE
Skipping unnecessary menus
To give a better overview, only menus relevant to the setup are described below. Unnecessary menus (such as
APPliC., SEnSOr, etc.) are not mentioned and can be skipped when selecting menu options.
Use the toggle key
3
briefly press the enter key
for about 3 seconds.
for about 3 seconds to confirm.
to select the SYS menu and
.
, select a new password with the toggle key
for about 3 seconds.
≥3S
≥3S
, then
≤1S
≤1S