Samsung BN68-02426A-00 User Manual page 36

Problem
Plasma TV is making humming noise.
Image Retention (Burn In) Issue.
Can not control TV power or volume
with Cable/Sat box remote control.
"Not Supported Mode" message.
Caption on TV menu is greyed out.
Plastic smell from TV.
TV Signal Strength is unavailable in the
Self Diagnostic Test menu.
TV is tilted to right or left side.
Can not assemble stand base.
Channel menu is grey out (unavailable).
Your settings are lost after 30 minutes
or every time TV is turned off.
Intermittent loss of audio or video.
You may see small particles if you
look closely at the edge of the bezel
surrounding the TV screen.
Input cables (Not supplied)
HDMI
Possible Solution
• Plasma TVs typically make a soft humming sound. This is normal. It's caused by the
electrical charges that are used to create the images on the screen.
• If the humming sound is loud, you may have set the brightness on the TV too high.
Try setting the brightness lower.
• You can also have loud humming if the back of your Plasma TV is too close to a wall
or other hard surface. Also try rerouting your connection cables.
• Improper installation of wall mount can create excessive noise.
• To minimize the possibility of screen burn, this unit is equipped with screen burn
reduction technology. Pixel Shift technology enables you to set picture movement up/
down (Vertical Line) and side to side (Horizontal Dot).
• Program the Cable/Sat remote control to operate the TV.
Refer to Cable/Sat user manual for SAMSUNG TV code.
• Check the supported resolution of the TV and adjust the external device's output
resolution accordingly. Refer to resolution settings in this manual.
• Caption can not be selected in the TV menu when connected via HDMI or
Component.
Caption
• must be activated on the external device.
• This smell is normal and will dissipate over time.
• This function is only available with digital channels with an Antenna (RF/Coax)
connection (Air or Cable).
• Remove the stand base from TV and reassemble.
• Make sure TV is placed on flat surface.
If can not remove screws from TV, please use magnetized screw driver.
• Channel menu is only available when TV source is selected (
• If TV is in the Store Demo mode, it will reset audio and picture settings every
30 minutes.
Please change from Store Demo mode to Home Use mode in the Plug & Play
procedure.
Press the SOURCE button to select TV mode, go to MENU → Setup → Plug & Play
→ ENTERE
• Check cable connections and reconnect.
• Can be caused by using overly rigid or thick cables.
Make sure the cables are flexible enough for long term use.
If wall mounting, we recommend using cables with 90 degree connectors.
• This is part of the product's design and is not a defect.
HDMI/DVI Component
English - 36
Antenna or Cable).
Composite (AV) Coaxial (RF)