Meridian DSP8000 XE Manual page 37

37 37
DSP8000 XE WITH G65 SURROUND CONTROLLER
Overview
When using a G65 with DSP8000 XE loudspeakers, the G65 acts as the hub for the sources within the system. Source products are connected to
the inputs on the G65 and the loudspeakers are connected using SpeakerLink cables. In addition, the B-Link Bluetooth module supplied with the
loudspeakers can be connected to the G65 to provide a means of streaming audio from a Bluetooth device such as a smartphone, tablet or PC.
Each loudspeaker must be set to play the appropriate audio channel. On the DSP8000 XE, this is done using the Channel Selector switch on the back-
panel. In this example, the DSW.2 should have its Channel Selector switch set to "2". Meridian loudspeakers featuring a digital display, such as the
DSP7200 SE, must be set using a Meridian remote control. Refer to the User Guide for how to do this.
Each Meridian loudspeaker can be connected to an individual SpeakerLink output on the G65 as shown above, or specific pairs can be "daisy-chained"
from a single SpeakerLink output. The pairs which can be daisy-chained are as follows:
• Left main and right main channels
• Left side and right side channels
• Left rear and right rear channel
• Centre-channel and Meridian subwoofer (acting as the LFE or Mono sub)
Additional Meridian subwoofers can be used in conjunction with any of the eight output channels above to complement or to augment bass output.
For advice on where to locate the loudspeakers within the room, refer to Positioning the loudspeakers to obtain the best sound on page 7.
POSITIONING THE
UNPACKING
INTRODUCTION
LOUDSPEAKERS
AND ASSEMBLY
CONNECTIONS MASTER B-LINK
AND CONTROLS AND SLAVE
IR CONTROL IA21 ANALOGUE SPECIFICATION
INPUT MODULE
SYSTEM
APPLICATIONS
MAINTENANCE TROUBLESHOOTING
AND CLEANING 12