Table of Contents
Advertisement
Installation:
LNB:
The installation menu provides access to LNB settings and features. These can expand the receivers
capabilities as well as customising the receiver to your preference.
Press Menu and select Installation to access the Installation menu:
The default LNB setting is as per the diagram above.
LNB Power:
This toggles the LNB power supply on and off. This option should be set to ON. With the LNB power
switched off, all control signals for LNB, switches and DiSEqC will also be disabled.
LNB A1 to D4:
Up to sixteen universal LNBs can be conntected to your digital receiver. For each LNB (A1 to D4) you
may specify the type and control method of the LNB.
L.O. Freq:
Enter the Local Oscillator Frequency in MHz of your LNB here. For LNBs with two L.O. frequencies,
enter the Low Band L.O. frequency in the Low column and the High Band L.O. frequency in the High
Column. (e.g. For a Universal LNB, the Low Band L.O. frequency is 9750 MHz and the High Band L.O.
Frequency is 10600 MHz).
Tone:
Your digital receiver is equipped with switch controls 12V, 22kHz tone, as well as DiSEqC 1.0
DiSEqC:
With the DiSEqC options switched on you can select between LNBs from A to D.
Note:
You may use these controls independently to select different LNBs, and in addition you can use either
in conjunction with DiSEqC switchs to increase the number of LNBs used. Up to maximum of sixteen
LNBs can be used.
Note: Universal LNBs uses 22kHz to switch between Low Band and High Band and therefore the
22kHz control column is automatically disabled when Univ is selected in the LNB column.
Save:
Highlight this button and press OK to store any changes made to this menu. If you exit by pressig
ESC your changes will not be saved.
LNB
<
A1
LNB
Univ
Low
09750
High
10600
DiSEqC
A
Tone
A
22k
Off
12v
Off
LNB Power
On
DiSEqC 1.0
Repeats
0
OFF
>
Help
Messages
Save
DiSEqC 1.0
Tone
OFF
22
Advertisement
Table of Contents
