Table of Contents
Advertisement
HOW TO INSTALL THE WHEEL
REMOVE CAP
INNER
FLANGE
REMOVE WHEEL
BOLT, WASHERS AND
OUTER FLANGE
BOX WRENCH
13×19 mm
TIGHTEN
WHEEL
BOX WRENCH
17×19 mm
SNAP CAP IN PLACE
1. Remove the cap from the arm for access to the shaft at front of the arm.
2. Two combination (17 mm, 19 mm) box wrenches are supplied. Use one
wrench to keep shaft from turning. Unscrew wheel mounting bolt with the
other wrench or your fingers. Remove wheel bolt, washers and outer
flange, leaving inner flange place. Mount wheel on arbor between the two
flanges. Install flat washer, lock washer and wheel bolt. Tighten bolt
securely and snap cap in place.
Before tightening, check that flanges are properly seated and not
cocked on the mount or bolt threads. Do not make bolt so tight as
to destroy the cushion supplied by the wheel blotters. Never fasten
while applying your weight. Otherwise the thread could be broken.
Do not tighten more than 20 N•m (15 ft. lbs.).
Inner and outer flanges are not interchangeable. Reversing
positions may cause wheel damage and lock the wheel.
NOTE
Arm may be removed and remounted with wheel on the outboard side of
the arm as required for certain procedures. See page 18 for details.
INNER FLANGE
ARM
PULLEY
SHAFT
V-BELT
WHEEL WITH BLOTTERS
25.4 mm ARBOR ADAPTER
WARNING
OUTER FLANGE
13
FLAT WASHER
WHEEL BOLT
LOCK WASHER
CSG-670 TYPE1-E
Advertisement
Table of Contents
