Table of Contents
Advertisement
Deleting Recorder Data
You can use the procedures below to delete an entire
recorder song or to delete a specific track of a recorder
song.
Deleting a Recorder Song
1.
Use the
(RECORDER) button to cycle
through the recorder modes until the
RECORDER lamp is lit (playback mode).
Lit: Playback mode
2.
While holding down the
button, press the
This displays the recorder song selection screen.
3.
(w, q) buttons to select the
Use the
recorder song you want to delete.
4.
Hold down the
(RECORDER) button until
the message "Sure?" appears on the display.
5.
Press the
(YES) button to delete the
recorder song.
• To cancel the delete operation, press the
button.
Deleting a Recorder Song Track
1.
Perform steps 1 through 3 of the procedure
under "Deleting a Recorder Song" to select
the recorder song that contains the track you
want to delete.
2.
Press the
(i) button.
This displays the track selection screen.
3.
(w, q) buttons to select the
Use the
track you want to delete.
4.
Hold down the
(RECORDER) button until
the message "Sure?" appears on the display.
5.
Press the
(YES) button to delete the track.
• To cancel the delete operation, press the
button.
(FUNCTION)
(RECORDER) button.
(NO)
(NO)
Re-recording Part of a
Recorder Song
(Punch-in Recording)
You can use punch-in recording to re-record a specific
part of recorder song that you want to improve or
correct.
Mistake
Playback
Use punch-in
recording to re-record
only this part.
1.
Turn on the recorder, enter the record mode,
and select the track that contains the section
you want to re-record.
• See step 3 under "Recording to a Specific Track
(Part)" (page E-35).
2.
Hold down the
(RECORDER) button until
the punch-in recording screen appears on the
display.
3.
Press the
(START/STOP) button.
This will start playback of the selected track.
4.
When playback reaches the point you want to
re-record, play the notes and perform the
other operations you want.
This automatically starts punch-in recording, which
will continue until step 5, below.
• Any one of the following also will start punch-in
recording: a pedal or pitch bend wheel operation;
pressing the
(RECORDER) button;
tone setting; changing the rhythm, or tempo setting
*1 Press
(RECORDER) when you want to start
punch-in recording without note input or a setting
change.
*2
System track only
• You can perform
(REW),
button operations during punch-in playback to jump
more quickly to the section you want to re-record.
Recording Your Keyboard Play
*1
changing the
(FF), and
(PAUSE)
E-37
*2
Advertisement
Table of Contents
