Advertisement
Advertisement
Table of Contents
Related Manuals for Bante Instruments TDSscan20
Summary of Contents for Bante Instruments TDSscan20
- Page 1 TDSscan20 Pocket TDS Tester USER MANUAL Bante Instruments Inc.
-
Page 2: Prior To Use
TDSscan20 MEAS Indicates that the tester is in the measurement mode Overview Indicates that the tester is in the calibration mode Thank you for selecting the TDSscan series pocket TDS tester. This user SETUP Indicates that the tester is in the setup mode... -
Page 3: Setup Menu
In the measurement mode, press and hold the Cal key to enter Setup Menu the setup menu. The TDSscan20 tester contains 7 menu items in the setup menu, the following table describes the functions of each option. Option Menu item... -
Page 4: Multipoint Calibration
Temperature Calibration The TDSscan20 tester is installed with a built-in temperature sensor for automatic temperature compensation. During the measurement, if the measured temperature reading differs from that of an accurate thermometer, the tester needs to be calibrated. -
Page 5: Replacing The Electrode
TDSscan20 • If the option is enabled in the setup menu, the tester will automatically lock the measurement endpoint and show HOLD icon. Press the Meas key to resume measuring. Press the Cal key to modify the temperature value. Electrode... - Page 6 Calibration Points 1 to 3 points Calculating the TDS Conversion Factor Temperature The TDSscan20 tester allows setting the conversion factor according Range 0 to 60°C (32 to 140°F) to the type of sample. The factory default is 0.50. The following formula Resolution 0.1°C (0.1°F)
-
Page 7: Warranty
Tel: (+1) 346-762-7358 E-mail: banteinstruments@yahoo.com Factory: F3, Building 2, No.2185, Laifang Rd., Shanghai 201615, China Tel: (+86) 21-6404-1598 E-mail: banteinstrument@hotmail.com The information in this document is subject to change without notice. www.bante-china.com Copyright © Bante Instruments Inc, 2022. All rights reserved.
Need help?
Do you have a question about the TDSscan20 and is the answer not in the manual?
Questions and answers