This testing should be performed by an authorized Directed dealer in accordance with the Safety Check outlined in this product installation guide. If the vehicle starts in gear, cease remote start operation immediately and consult with the user to fix the problem immediately.
Introduction The FORD9 firmware for Directed Digital Systems is a complete solution for remote start, security (if applicable), bypass interface, and convenience needs compatible with specific Ford and Lincoln vehicles. Warning! This module can only be programmed via the web tool, which can be found on www.directechs.com or using the Directechs Mobile application for smartphones.
Any first-time user must re-register to gain access to Key2GO, and some additional information will be required to complete the registration process, such as your Directed account number and store name. Key2GO requires an XKLoader.
Manual or automatic transmission selection The yellow loop on the Directed Digital System controls which transmission type the unit is configured for. The state of the loop (uncut or cut) when the main module is powered up will determine which type is selected.
Please follow the instructions included with the kit for appropriate installation and programming information. When flashing the Directed Digital System, make sure to pick the remote you will be using. This way the main module will have the necessary firmware to interact with the remote and Control Center (antenna) combination.
Connect all but the white 12-pin harness Connect all the harnesses to the Directed Digital System, EXCEPT the white12-pin main power harness. Must be connected LAST Connect the white12-pin main power harness, and &...
Directed dealer; the unit will be professionally reinstalled in the vehicle in which it was originally installed by an authorized Directed dealer; and the unit is returned to Directed, shipping prepaid with a legible copy of the bill of sale or other dated proof of purchase bearing the following information: consumer’s name, telephone number and address;...
Page 21
Pit stop mode SmartStart compatible This system is compatible with Directed SmartStart 3.0. For a complete list of Stop the vehicle in a safe parking spot and put the gear in supported features, please visit www.mysmartstart.com. gear in Park (P).
Page 23
Stop the vehicle in a safe parking spot and put the gear in gear in Park (P). Park This system is compatible with Directed SmartStart 3.0. For a complete list of supported features, please visit www.mysmartstart.com. Press the Remote Start button on the transmitter.* What is SmartStart? 14:36 &...