Table of Contents
Advertisement
Installation
BLOWER ASSEMBLY
1. Remove the existing 5/16-18 x 5/8" flange head
bolts (B, Figure 11) from the blower housing (A).
2. Install the blower mount plate (C) onto the blower
housing and reinstall the 5/16-18 x 5/8" flange
head bolts. Tighten securely.
3. Install three (3) 3/8-16 x 1" bolts and nylon lock
nuts (D) through the blower mount plate and
blower. The bolt heads must be installed on the
inside of the blower housing.
4. Loop the idler spring (A, Figure 12) through the
1/4" x 2" eyebolt (B). Install the eyebolt through
the L-bracket on the blower mount and install the
1/4-20 nylock flange nut (C). Tighten the nut until
the eyebolt contacts the L-bracket.
12
A
B
Figure 11. Install Blower Mount Plate
A. Blower Housing
B. 5/16-18 x 5/8" Bolts (existing)
C. Blower Mount Plate
D. 3/8-16 x 1" Bolts & Nylon Lock Nuts (3X)
E
D
Figure 12. Install Idler Spring
A. Idler Spring
B. 1/4" x 2" Eyebolt
C. 1/4-20 Nylock Flange Nut
D. Spring Anchor Bolt
E. Idler Arm
www.ferrismowers.com | www.snapperpro.com
B
C
D
C
B
A
Advertisement
Table of Contents
