Installation
Assemble Collector Hood
1. Install the inlet tube (B, Figure 36) to the collector
back plate (A) and secure with the 5/16-18 x 3/4"
bolts (C) and 5/16-18 nylock flange nuts (D).
2. Install the mount posts (E) on the back plate and
loosely secure with the 3/8-16 x 1" bolts (F) and
3/8-16 nylock flange nuts (G).
NOTE: On the 3-bag collector back plate, install
the eight (8) supplied hole plugs in the remaining
mounting holes not used.
C
B
2 Bag Collector
B
3 Bag Collector
Figure 36. Assemble Collector Hood
A. Collector Back Plate
B. Inlet Tube
C. 5/16-18 x 3/4" Bolt
D. 5/16-18 Nylock Flange Nut
E. Collector Mount Post
F. 3/8-16 x 1" Bolt
G. 3/8-16 Nylock Flange Nut
22
D
C
D
3. Install the collector onto the mount plate and
secure with the hitch pins as shown in Figures
33 & 36. Again, this will insure that the holes are
properly aligned for easy installation and removal..
Tighten the 3/8-16 x 1" bolts securing the posts to
the back plate.
NOTE: It is recommended that the rear suspension
be adjusted stiffer due to the added weight of
the collection system (see operators manual for
procedure).
A
E
F
A
E
F
www.ferrismowers.com | www.snapperpro.com
G
G