Alpine CDE-9828RB Service Manual page 10

Step Description Connection
Signal Meter
Auto
3 Figure 4
Adjustment
(LW)
FM ST
Separation
4 Figure 5
(Roll OFF)
Adjustment
Stereo Blend
(Roll OFF)
5 Figure 5
Adjustment
(Lch)
Limitting
6 Figure 6
Adjustment
All manuals and user guides at all-guides.com
Signal Generator Dial Control
216kHz ,
(1) 34dBµ 216kHz
(Mod. OFF)
216kHz ,
(2) 34dBµ 216kHz
(Mod. OFF)
216kHz ,
(3) 29~31dBµ 216kHz
(Mod. OFF)
216kHz ,
(4) 34dBµ 216kHz
(Mod. OFF)
(1) —
98.1MHz, 72dBµ
(Mod. 400Hz,
(2) Dev. 75kHz, 98.1MHz
Stereo, 1kHz,
Lch only)
(3) —
(1) —
98.1MHz, 46dBµ
(Mod. 400Hz,
(2) Dev. 75kHz, 98.1MHz
Stereo, 1kHz,
Lch only)
(3) —
(1) —
98.1MHz, 24dBµ
(2) (Mod. 400Hz, 98.1MHz
Dev. 75kHz)
(3) —
CDE-9828RB/CDE-9827R/
CDE-9827RM/CDE-9827RR
Test Point /
P .W.Board
Coordinates
TP002 Auto Adjustment :
(3-F) After setting up of Signal Genarator,
TP511 short GND and TP511 (Pull-Down)
(3-B) for 2~3 seconds.
Proceed same Auto Adjustment of step
(1) under step (2).
TP002 (SPEC) TP002 : 1.0±0.1V
(3-F) (SPEC) TP002 : others 1.0±0.1V
TP511
(3-B) NOTE : NG : Proceed same Auto
TP002
(3-F) Proceed same Auto Adjustment of step
TP511 (1) under step (3).
(3-B)
TP002
(3-F) Proceed same Auto Adjustment of step
TP511 (1) under step (4).
(3-B)
Set up of Adjustment Mode :
— — Push SOURCE/POWER +
3 at the same time.
Push Preset Switches (1~5), and
observe value of separation.
Audio Output
Select Preset Switch of maximum
(RCA)
separation.
(SPEC) : separation : more than 20dB.
Cancel Adjustment Mode :
— — Push SOURCE/POWER +
3 at the same time.
Set up of Adjustment Mode :
— — Push SOURCE/POWER +
F at the same time.
Push Preset Switches (1~6), and
Audio Output
observe value of blend.
(RCA)
(SPEC) : Blend : 8±6dB.
Cancel Adjustment Mode :
— — Push SOURCE/POWER +
F at the same time.
Set up of Adjustment Mode :
— — Push SOURCE/POWER +
UP at the same time.
Push Preset Switches (1~5), and
Audio Output
observe value of limitting.
(RCA)
(SPEC) : Limitting : -3dB.
Cancel Adjustment Mode :
— — Push SOURCE/POWER +
UP at the same time.
Adjustment
OK
NG
Adjustment of step (1)
under step (3).