Strymon DIG User Manual page 31

DIG
- dual digital delay
STEP 2 – SET MIDI CHANNEL
4 Press either footswitch to exit and store your MIDI Channel setting
and begin using DIG�
NOTE: A simple way to check that communication is working is to send CC
#102 with a value of 127 when the ON footswitch is off� This will enable the
ON footswitch if MIDI is properly connected and configured�
NOTE: If you are only sending data to DIG using the Strymon MIDI EXP Cable,
the MIDI OUT mode must be set to OFF� (See
figuring the MIDI OUT mode�)
NOTE: MIDI Channel assignment is not saved per Favorite setting or MIDI
preset�
(CONT�)
page 32
for details on con-
pg 31